ASRock p4i65pe Boot Screen, Boot Settings Configuration, Boot From Network, Boot Up Num-Lock

Page 32

3.5 Boot Screen

In this section, it will display the available devices on your system for you to config- ure the boot settings and the boot priority.

BIOS SETUP UTILITY

Main

Advanced

H/W Monitor

Boot

Security Exit

Boot Settings

Boot Settings Configuration

 

1st Boot Device

[1st Floppy Device]

2nd Boot Device

[2nd Floppy Device]

3rd Boot Device

[3rd Floppy Device]

Hard Disk Drives

 

Removable Drives

 

CD/DVD Drives

 

Configure Settings during System Boot.

 

Select Screen

 

Select Item

Enter

Go to Sub Screen

F1

General Help

F9

Load Defaults

F10

Save and Exit

ESC

Exit

v02.54 (C) Copyright 1985-2003, American Megatrends, Inc.

3.5.1 Boot Settings Configuration

BIOS SETUP UTILITY

Boot

Boot Settings Configuration

Boot From Network

[Disabled]

Bootup Num-Lock

[On]

To enable or disable the boot from network feature.

Select Screen

Select Item

+- Change Option

F1 General Help

F9 Load Defaults

F10 Save and Exit ESC Exit

v02.54 (C) Copyright 1985-2003, American Megatrends, Inc.

Boot From Network

Use this item to enable or disable the Boot From Network feature.

Boot Up Num-Lock

If this item is set to [On], it will automatically activate the Numeric Lock function after boot-up.

3 2

Image 32
Contents P4i65PE Copyright Notice DisclaimerContents Software Support Package Contents IntroductionSpecifications Bios Motherboard Layout 20.8cm 8.2ASRock 8CH I/O Table for Audio Output ConnectionInstallation Pre-installation PrecautionsCPU Installation Installation of CPU Fan and HeatsinkInstallation of Memory Modules Dimm Dual Channel Memory ConfigurationsInstalling a Dimm Notch breakInstalling an expansion card Expansion Slots PCI and AGP SlotsJumpers Setup PS2USBPWR1Onboard Headers and Connectors IDE2USB 2.0 Header Chassis Speaker Header Serial ATA Sata Hard Disks Installation Bios Setup Utility Bios Menu BarAdvanced Screen Navigation KeysMain Screen CPU Configuration CPU Host FrequencySpread Spectrum Ratio StatusChipset Configuration Configure Dram Timing by SPD Dram RAS# to CAS# DelayDram Precharge Delay Dram FrequencyAcpi Configuration IDE Configuration OnBoard IDE Operate ModeCombined Mode Option OnBoard IDE ControllerIDE Device Configuration LBA/Large ModePCIPnP Configuration Floppy Configuration Super IO ConfigurationOnBoard Floppy Controller Serial Port AddressParallel Port Mode ECP Mode DMA ChannelParallel Port Address EPP VersionUSB Configuration Hardware Health Event Monitoring ScreenUSB Controller USB 2.0 SupportBoot Screen Boot Settings ConfigurationBoot From Network Boot Up Num-LockHDD PM-MAXTOR 6L08 Boot Device PrioritySecurity Screen Load Optimal Defaults Exit ScreenSave Changes and Exit Discard Changes and ExitSoftware Support