ASRock p4i65pe manual Boot Device Priority, Security Screen, HDD PM-MAXTOR 6L08

Page 33

3.5.2 Boot Device Priority

In this section, you may specify the boot sequence from the available devices in your system.

BIOS SETUP UTILITY

Boot

Boot Device Priority

1st Boot Device

[1st FLOPPY DRIVE]

2nd Boot Device

[HDD: PM-MAXTOR 6L08]

3rd Boot Device

[CD / DVD]

Specifies the boot sequence from the available devices.

A device enclosed in parenthesis has been disabled in the corresponding type menu.

Select Screen

Select Item

+- Change Option

F1 General Help

F9 Load Defaults

F10 Save and Exit ESC Exit

v02.54 (C) Copyright 1985-2003, American Megatrends, Inc.

Likewise, you may also specify the boot sequence from the available devices for the hard disk drives, the removable drives, and the CD/DVD drives.

3.6 Security Screen

In this section, you may set or change the supervisor/user password for the system. For the user password, you may also clear it.

BIOS SETUP UTILITY

Main

Advanced

H/W Monitor

Boot

Security

Exit

Security Settings

Supervisor Password

: Not Installed

User Password

: Not Installed

Change Supervisor Password

Change User Password

Install or Change the password.

 

Select Screen

 

Select Item

Enter

Change

F1

General Help

F9

Load Defaults

F10

Save and Exit

ESC

Exit

v02.54 (C) Copyright 1985-2003, American Megatrends, Inc.

3 3

Image 33
Contents P4i65PE Disclaimer Copyright NoticeContents Software Support Introduction Package ContentsSpecifications Bios 20.8cm 8.2 Motherboard LayoutTable for Audio Output Connection ASRock 8CH I/OPre-installation Precautions InstallationInstallation of CPU Fan and Heatsink CPU InstallationDual Channel Memory Configurations Installation of Memory Modules DimmNotch break Installing a DimmExpansion Slots PCI and AGP Slots Installing an expansion cardPS2USBPWR1 Jumpers SetupIDE2 Onboard Headers and ConnectorsUSB 2.0 Header Chassis Speaker Header Serial ATA Sata Hard Disks Installation Bios Menu Bar Bios Setup UtilityNavigation Keys Main ScreenAdvanced Screen CPU Host Frequency CPU ConfigurationSpread Spectrum Ratio StatusChipset Configuration Dram RAS# to CAS# Delay Configure Dram Timing by SPDDram Precharge Delay Dram FrequencyAcpi Configuration OnBoard IDE Operate Mode IDE ConfigurationCombined Mode Option OnBoard IDE ControllerLBA/Large Mode IDE Device ConfigurationPCIPnP Configuration Super IO Configuration Floppy ConfigurationOnBoard Floppy Controller Serial Port AddressECP Mode DMA Channel Parallel Port ModeParallel Port Address EPP VersionHardware Health Event Monitoring Screen USB ConfigurationUSB Controller USB 2.0 SupportBoot Settings Configuration Boot ScreenBoot From Network Boot Up Num-LockBoot Device Priority Security ScreenHDD PM-MAXTOR 6L08 Exit Screen Load Optimal DefaultsSave Changes and Exit Discard Changes and ExitSoftware Support