ASRock p4i65pe manual Specifications

Page 6

1.2 Specifications

Platform:

ATX Form Factor: 12.0-in x 8.2-in, 30.5 cm x 20.8 cm

CPU:

Socket 478, supports Intel® Pentium® 4 / Celeron® (Prescott,

 

Northwood, Willamatte) processor

Chipsets:

North Bridge:

 

Intel® 865PE chipset, FSB @ 800 / 533 / 400MHz,

 

supports Hyper-Threading Technology (see CAUTION 1)

 

South Bridge:

 

Intel® ICH5, supports SATA 1.5Gb/s

Memory:

4 DDR DIMM Slots: DDR1, DDR2, DDR3, and DDR4

 

4 DDR DIMM Slots Supports PC3200 (DDR400) / PC2700

 

(DDR333) / PC2100 (DDR266), Max. 4GB

 

(see CAUTION 2)

 

Dual Channel Memory Technology support (see CAUTION 3)

IDE:

IDE1: ATA 100 / Ultra DMA Mode 5

 

IDE2: ATA 100 / Ultra DMA Mode 5

 

Supports up to 4 IDE devices

Serial ATA:

Supports up to 2 SATA devices at 1.5Gb/s data transfer rate

 

(Not Support “RAID and “Hot Plug” functions)

Floppy Port:

Supports up to 2 floppy disk drives

Audio:

7.1 channels AC’97 Audio

PCI LAN:

Speed: 802.3u (10/100 Ethernet), supports Wake-On-LAN

Hardware Monitor: CPU temperature sensing,

 

Chassis temperature sensing,

 

CPU overheat shutdown to protect CPU life

 

(ASRock U-COP)(see CAUTION 4),

 

CPU fan tachometer,

 

Chassis fan tachometer,

 

Voltage monitoring: +12V, +5V, +3.3V, Vcore

PCI slots:

5 PCI slots with PCI Specification 2.3

AGP slot:

1 AGP slot, supports 1.5V, 8X/4X AGP card (see CAUTION 5)

USB 2.0:

8 USB 2.0 ports:

 

includes 4 default USB 2.0 ports on the rear panel,

 

plus two headers to support 4 additional USB 2.0 ports

 

(see CAUTION 6)

ASRock 8CH I/O: 1 PS/2 Mouse Port, 1 PS/2 Keyboard Port

1 Serial Port: COM1

1 Parallel Port (ECP/EPP Support)

4 Ready-to-Use USB 2.0 Ports

1 RJ-45 Port

6

Image 6
Contents P4i65PE Copyright Notice DisclaimerContents Software Support Package Contents IntroductionSpecifications Bios Motherboard Layout 20.8cm 8.2ASRock 8CH I/O Table for Audio Output ConnectionInstallation Pre-installation PrecautionsCPU Installation Installation of CPU Fan and HeatsinkInstallation of Memory Modules Dimm Dual Channel Memory ConfigurationsInstalling a Dimm Notch breakInstalling an expansion card Expansion Slots PCI and AGP SlotsJumpers Setup PS2USBPWR1Onboard Headers and Connectors IDE2USB 2.0 Header Chassis Speaker Header Serial ATA Sata Hard Disks Installation Bios Setup Utility Bios Menu BarNavigation Keys Main ScreenAdvanced Screen Spread Spectrum CPU ConfigurationCPU Host Frequency Ratio StatusChipset Configuration Dram Precharge Delay Configure Dram Timing by SPDDram RAS# to CAS# Delay Dram FrequencyAcpi Configuration Combined Mode Option IDE ConfigurationOnBoard IDE Operate Mode OnBoard IDE ControllerIDE Device Configuration LBA/Large ModePCIPnP Configuration OnBoard Floppy Controller Floppy ConfigurationSuper IO Configuration Serial Port AddressParallel Port Address Parallel Port ModeECP Mode DMA Channel EPP VersionUSB Controller USB ConfigurationHardware Health Event Monitoring Screen USB 2.0 SupportBoot From Network Boot ScreenBoot Settings Configuration Boot Up Num-LockBoot Device Priority Security ScreenHDD PM-MAXTOR 6L08 Save Changes and Exit Load Optimal DefaultsExit Screen Discard Changes and ExitSoftware Support