ASRock p4i65pe manual Exit Screen, Save Changes and Exit, Discard Changes and Exit

Page 34

3.7 Exit Screen

BIOS SETUP UTILITY

Main

Advanced

H/W Monitro

Boot

Security

Exit

Exit Options

Save Changes and Exit

Discard Changes and Exit

Discard Changes

Load Optimal Defaults

Exit system setup after saving the changes.

F10 key can be used for this operation.

 

Select Screen

 

Select Item

Enter

Go to Sub Screen

F1

General Help

F9

Load Defaults

F10 Save and Exit

ESC

Exit

v02.54 (C) Copyright 1985-2003, American Megatrends, Inc.

Save Changes and Exit

When you select this option, it will pop-out the following message, “Save configuration changes and exit setup?” Select [OK] to save the changes and exit the BIOS SETUP UTILITY.

Discard Changes and Exit

When you select this option, it will pop-out the following message, “Dis- card changes and exit setup?” Select [OK] to exit the BIOS SETUP UTILITY without saving any changes.

Discard Changes

When you select this option, it will pop-out the following message, “Dis- card changes?” Select [OK] to discard all changes.

Load Optimal Defaults

When you select this option, it will pop-out the following message, “Load optimal defaults?” Select [OK] to load the default values for all the setup configurations.

3 4

Image 34
Contents P4i65PE Copyright Notice DisclaimerContents Software Support Package Contents IntroductionSpecifications Bios Motherboard Layout 20.8cm 8.2ASRock 8CH I/O Table for Audio Output ConnectionInstallation Pre-installation PrecautionsCPU Installation Installation of CPU Fan and HeatsinkInstallation of Memory Modules Dimm Dual Channel Memory ConfigurationsInstalling a Dimm Notch breakInstalling an expansion card Expansion Slots PCI and AGP SlotsJumpers Setup PS2USBPWR1Onboard Headers and Connectors IDE2USB 2.0 Header Chassis Speaker Header Serial ATA Sata Hard Disks Installation Bios Setup Utility Bios Menu BarMain Screen Navigation KeysAdvanced Screen Spread Spectrum CPU ConfigurationCPU Host Frequency Ratio StatusChipset Configuration Dram Precharge Delay Configure Dram Timing by SPDDram RAS# to CAS# Delay Dram FrequencyAcpi Configuration Combined Mode Option IDE ConfigurationOnBoard IDE Operate Mode OnBoard IDE ControllerIDE Device Configuration LBA/Large ModePCIPnP Configuration OnBoard Floppy Controller Floppy ConfigurationSuper IO Configuration Serial Port AddressParallel Port Address Parallel Port ModeECP Mode DMA Channel EPP VersionUSB Controller USB ConfigurationHardware Health Event Monitoring Screen USB 2.0 SupportBoot From Network Boot ScreenBoot Settings Configuration Boot Up Num-LockSecurity Screen Boot Device PriorityHDD PM-MAXTOR 6L08 Save Changes and Exit Load Optimal DefaultsExit Screen Discard Changes and ExitSoftware Support