Boot
Sets the sequence of system boot devices.
▶Full
Screen Logo Display [Enabled]
Enables or disables to show the full screen logo while system POST.
[Enabled] | The OS boots straight to the GUI without showing the POST screen. |
[Disabled] | Shows the POST messages at booting. |
▶Boot Mode Select [LEGACY+UEFI]
Sets the system boot mode from legacy or UEFI architecture depending on OS installation requirement.
[UEFI] | Enables UEFI BIOS boot mode support only. |
[LEGACY+UEFI] | Enables both Legacy BIOS boot mode and UEFI BIOS boot |
| mode. |
▶FIXED BOOT ORDER Priorities Sets device priority for system boot.
▶Boot Option #1~N
These items are used to prioritize the installed boot devices.
Security
▶Administrator Password
Sets administrator password for system security. Enters the administrator password if set; user has full rights to change the BIOS items.
▶User Password
Sets User Password for system security. Enters the user password if set; but user might have limited rights to change the BIOS items.
Important
When selecting the Administrator / User Password items, a password box will appear on the screen. Type the password then press <Enter>. The password typed now will replace any previous set password from CMOS memory. You will be prompted to confirm the password. You may also press <Esc> to abort the selection.
To clear a set password, press <Enter> when you are prompted to enter a new password. A message will confirm the password is being disabled. Once the password is disabled, you can enter the setup and OS without authorization.
▶
Enables or disables
▶Make
Makes a key at the USB flash drive to prevent other people from accessing the system. Only the user who has the key with the flash drive can access the system.
▶Chassis Intrusion Configuration Press <Enter> to enter the
Chapter 3
BIOS Setup |