Installation

Important

INSTALLATION AND SETUP SHOULD BE CARRIED OUT BY AN AUTHORISED TECHNICIAN IN LINE WITH CURRENT

INSTALLATION STANDARDS.

Positioning the hobs

Minimum distances to walls

fig. 1

A gap with the dimensions shown in figure 1 will be cut into the worktop or stove.

The system for fixing the hob is intended for use with kitchen units with a thickness of 20, 30 or 40 mm.

In free-standing models, a shelf should be placed inside the unit. The minimum dis- tance between the lower part of the hob and the upper part of the shelf should be 20 mm.

The hobs described in this manual can only be installed with TEKA ovens.

The minimum distance between the surfa- ce supporting the cooking pans and the lower part of the kitchen unit or the hood located above’ the hob should be 650 mm. If the hood s installation instructions recom- mend that the gap is greater than this, you should follow this advice.

The unit where the hob and oven will be located will be suitably fixed.

When hobs are handled before being installed, care should be taken in case there is any protruding part or sharp edge which could cause injury.

TEKA does not accept liability for any malfunction or damage that may be caused by faulty installation.

The glues used in manufacturing the kitchen unit and in the adhesive on

Minimum ventilation distances

40 mm minimum

OVEN

Installation space

	m
	u
	im
x
a
m

the decorative laminate of the worktop surface should be made to tolerate tem- peratures of up to 100ºC.