GB
The glass covers can shatter when they heat up. Turn off the burners before closing the cover.
Positioning the oven
See the corresponding manual.
Fixing the hob
When the gap has been properly sized, the sealing washer (J) should be put on the part of the cooker.
Position the clips (K) as shown in figure 2, fastening them to the openings in the lower part of the body usingØ the metal thre- aded screws provided ( 4.2 mm).
The clips (K) and the sealing washer (J) are provided, and can be found in the pac- kaging.
For worktop thicknesses of less than 30 mm., use the
clip to the worktop.
Connecting the gas
Connecting the hob to the gas mains should be done in compliance with the current installation standards and regula- tions.
Ventilation slots should also be made at the site in compliance with current norms.
The hob is ”provided with a threaded con- nection 1/2Ø in diameter, in line with ISO
8
fig. 2 |
40 mm |
30 mm |
20 mm |
Whenever the gas connection nut is remo- ved, its washer should be changed.
In order that the hob is not damaged by tightening the nut on the gas connection pipe, a maximum torque of 350 cm * Kgf should be applied.
When the gas connection has been made, the installation should be checked to ensu- re that it is completely sealed. If the check is done using air, care should be taken that the test pressure is no more than 200 gr./cm2. Where air is not available, soapy water should be applied to ensure Testhat- thereing shouldare no leaksneverin thebeconnectionsdone using. a flame.
When the hob has been installed, check that the burner minimums are properly