Cleaning and Maintenance

Telescopic Guides

Sliding supports that help you to remove the accessories from the oven guaranteeing their handling without these tilting.

Catalytic Panels

They have a rough finish that allows self- cleaning to be carried out. (See the section on cleaning).

Turnspit

For the installation and handling of the turnspit, refer to the characteristics sheet of your oven. We recommend you to place the tray beneath to collect the fat and juices.

Door Switch

On opening the door, the elements and fan inside the oven are automatically switched off. When the door is closed again, the oven resumes working at the selected settings.

Tray Handle

The tray handle is used when you need to move the tray to check the cook. To handle the tray out the oven, you need to use gloves to protect yourselve.

Crystal Clean Enamel

Special enamel which allows a main facility of oven cleaning.

Caution

To carry out any action, the appliance must be disconnected from the mains electricity supply.

Cleaning the Inside of the Oven

•Clean the inside of the oven to eliminate food and grease residues, which can give off smoke or odours and cause stains to appear.

•With the oven cold and for enamelled surfaces (e.g. the floor of the oven) use nylon brushes or sponges with warm soapy water. If using special oven cleaning products, use only on enamelled surfaces and following the manufacturer’s instructions.

Caution

Do not clean the inside of your oven with a steam or pressurised water jet. Do not use either metallic scouring pads or any material that could scratch the enamel.

•Most models have a catalytic cleaning system (self-cleaning). This system eliminates small grease residues during cooking at high temperatures.

•If grease residues remain after cooking, these can be eliminated with the oven empty at 250ºC for one hour.

Use of the Fold-down Grill (Depending on Model)

To clean the upper part of the oven,

•Wait until the oven is cold.

•Turn the screw (A) and lower the grill element as far as possible.

•Clean the upper part of the oven and return the grill element to its initial position.

Cleaning the Catalytic Panels

If the food remains resist normal cleaning (self-cleaning), then:

1Remove the panels and leave them to soak as long as is necessary to soften the food residues.

2Clean the panels, wiping them with a sponge and clean water.

3Dry the panels and re-assemble them in the oven.

4Connect the oven for one hour at 250ºC.

Caution

Do not use commercial cleaning products or abrasive powders on catalytic panels.

Instructions for Removing the Catalytic Side Panels with Tray Guides.

1 Remove the accessories from inside the oven.

2Loosen the bolt (A) and easing the panels outwards, remove them from their location.

ENGLISH