Lennox International Inc 51M32 operation manual Fan Control

Page 10

Setpoint Display and Adjustment

ROOM 69

FAN

AUTO

SETPOINT 64 SYSTEM

HEAT

Figure 9

After the desired setpoint is reached, the HOME screen will reappear after about 8 seconds.

Fan Control

The FAN button is located behind the small door on the right-hand side of the thermostat. See figure 3. The FAN button can be used to select either continuous fan mode or auto fan mode.

If continuous fan mode is enabled, the fan will run continu- ously regardless of whether the heating or cooling equip- ment is running. Also, ON will be displayed in the FAN box as shown in figure 10.

Fan ON with Icon

ROOM 73

FAN

ON

SYSTEM

HEAT

Figure 10

If auto fan mode is selected, the fan will only run when the heating or cooling equipment is running. In this case, AUTO will be displayed in the FAN box as shown in figure 11.

Fan AUTO with Icon

ROOM 73

FAN

AUTO

SYSTEM

HEAT

Figure 11

To change from continuous to auto fan mode and vice versa, press the FAN button. Also note the presence of a fan icon in the FAN box. This icon indicates that the fan is running.

Filter Reminder

The 51M33 thermostat includes a filter reminder feature. The filter reminder can be set for 1, 3, 6, or 12−month inter- vals. The SETTINGS button, located behind the door on the right−hand side of the thermostat is used to set the filter reminder interval. See figure 3. Press the SETTINGS but- ton from the HOME screen to display the Filter Reminder Settings screen as shown in figure 12.

Filter Reminder Settings

0 Filter

Figure 12

The default setting for the filter reminder is 0, which dis- ables the function. Use the UP arrow while in the Filter Re- minder Settings screen to select the desired interval be- tween reminders. It may be necessary to press the UP arrow several times to access the desired setting. The HOME screen will reappear about 10 seconds after the ar- row key has been pressed for the final time.

After the programmed interval has elapsed, the FILTER re- minder will be displayed as shown in figure 13. After the fil- ter has been changed, reset the filter reminder by pressing the SETTINGS button for 4 seconds. The screen will blink for a few moments to indicate that the timer has been reset.

Page 4

Image 10
Contents MeritR Series Thermostat Table of ContentsInitial Thermostat Power-up GeneralHeating Control Heat Mode EnabledHeat Mode Disabled Display − Home ScreenSetpoint Display and Adjustment Adjusting Temperature SetpointEnabling and Disabling Cool Mode Cooling ControlFan Control Filter ReminderDefault Thermostat Settings Service IndicatorThermostat Reset Technical SpecificationsThermostat Output Table Controls 51M33 Normal Heat Mode Enabled Additional Thermostat Buttons Normal Heat ModeEmergency Heat Mode Emergency Heat Mode EnabledCooling Control Fan Control Service Indicator Flashing Room Balance Point SettingBalance Point 51M33 Terminal Designations Backup Heat Source SelectionBalance Point Thermostat Output Table Electric Heat Backup − Outdoor Sensor Attached Electric Heat Backup − No Outdoor SensorGas Heat Backup Dual Fuel − No Outdoor Sensor Gas Heat Backup Dual Fuel − Outdoor Sensor Attached