Tefal BL310A38 manual 25L for thick mixtures 1L for liquid preparations

SM_BLENDERFORCE_FACICLIC_500W_EE_8080013643_8080013643 26/05/14 15:48 Pa

base of the jug (c3). Lock it by rotating the blade unit through a quarter turn in the anticlockwise direction. (Fig. 2).

•Introduce the ingredients into the assembled jug without exceeding the maximum level indicated:

*1.25L for thick mixtures

*1L for liquid preparations.

•Lock the lid (c4) on the jug. Place the measuring cup (c5) in its recess on the lid.

•Place the blender jug assembly (C)

on the motor unit (A). The red lock

(open is aligned in the slot on the motor unit. (Fig. 3 - position 1)

•Then rotate the blender jug (C)

through a quarter turn until the green

lock (closed) appears. (Fig. 3 - position 2).

2 jug positions are possible: handle on the right or left of the motor unit.

•Do not use the blender for more than three minutes at a time.

•With the herb chopper (D) you can chop ingredients like onions, garlic, meat (cut into pieces) and dry fruits in a few seconds, make crumbs (rusk).

Do not use the herb chopper for liquid preparations (fruit juices, etc.)

•With the spice grinder (E) you can grind spices in a few seconds: coriander seeds, pepper, etc.

•These accessories are equipped with a bowl (F) that prevents access to the blades during use.

1- Rotate the bowl (F) and pour the ingredients.

2- Position the gasket (d1) or (e1) in

its recess on the blade unit (d2 or e2). (Fig. 4). Position the blade unit on the bowl aligning both the marks on the bowl and the blade unit. Lock the accessory by rotating the blade unit through a quarter turn in the anticlockwise direction. (Fig. 5).

Caution: leaks can occur if the accessory is not locked correctly.

3- Rotate the assembled assembly (D or E) and position it on the motor unit. The red lock (open) is aligned in the slot on the motor unit. (Fig 6 - position 1)

4- Then rotate the assembled accessory (D or E) through a quarter turn clockwise until the green lock (closed) appears. (Fig. 6 - position 2).

5- Plug in the appliance and turn the speed selector (B) to the desired position or apply a few pulses. Hold the bowl (F) when the appliance is running. To stop the appliance, turn the speed selector (B) back to position “0”.

6- Unlock the accessory by rotating it through a quarter turn in the anticlockwise direction, until the red lock (open) appears. Remove the assembled accessory (D, E) from the motor unit.

Turn it over on the worktop before unlocking the blade unit (d2, e2) from the bowl (F) in the reverse order of the assembly. The blades are very sharp: handle them with caution to avoid injury.

You can then collect the preparation in the bowl.

*The colour of the bowl may change after blending certain very hard ingredients: (cloves, cinnamon, etc.).

54