Installation Instructions
5
D
E
INSTALL OUTER CASE IN WINDOW
Thread nut onto bolt, then thread the bolt into the triangle bracket as shown in the figure below.
Attach triangle bracket onto bottom of case using three type B screws for each bracket. Make sure that the bracket is close enough to the outside wall that the bolt can touch. Adjust bolt so that it is snug against the outside wall.
NOTE: A block of wood can be placed between the bolt and the outside wall if the bolt rests between studs.
7COMPLETE INSTALLATION
AInsert the foam seal behind the top of the lower window sash and against the glass of the upper window.
A
B
A. Top of lower window sash
B. Foam seal
BPlace the window lock bracket as shown. Use a 1/8” drill bit to drill a starter hole through the hole in the window lock bracket and into the upper window.
CAUTION:
To prevent broken glass or damage to windows, on vinyl or other similarly constructed windows, attach the window locking bracket to the window side jamb with one type B screw.
CAttach the window lock bracket to the upper window with a type C screw to secure the window in place.
Wood
Vinyl
11