Installation Instructions
1WINDOW REQUIREMENTS
These instructions are for a standard
The air conditioner can be installed without the side curtain panels if needed to fit in a narrow window. See the window opening dimensions.
All supporting parts must be secured to firm wood, masonry or metal.
The electrical outlet must be within reach of the power cord.
Follow the dimensions in the table and illustration for your model.
20 1/4”
31 1/4” - 40” (With side curtain panels)
2STORM WINDOW REQUIREMENTS
A storm window frame will not allow the air conditioner to tilt toward the outside, and will keep it from draining properly. To adjust for this, attach a piece of wood to the sill.
WOOD PIECES
WIDTH: 2σ
LENGTH: Long enough to fit inside the window frame.
THICKNESS: To determine the thickness, place a piece of wood on the sill to make it 1/2σ higher than the top of the storm window frame or the vinyl frame.
Attach securely with nails or screws provided by the installer.
1/2σhigher | Wood | |
| ||
than storm |
| |
window | Sill | |
frame | ||
| ||
Storm window | Vinyl frame | |
frame | ||
|
3PREPARE THE AIR CONDITIONER
ARemove two screws on each side of the case. Save the screws for use later. Two screws on the top of the case are covered by black adhesive. Remove adhesive and screws.
BInsert a flat head screw driver between the front grille and the metal case along the sides. Gently pry the grille from the case. NOTE: Cover the flat head screw driver with tape to prevent scratching the case.
CUsing the handle on bottom front of the air conditioner, pull air conditioner out of the case. The air conditioner is very heavy so make sure that it will be resting on a sturdy surface.
9