Carrier 48/50HJ004-014 specifications Cont

Table 1B — Electrical Data (COBRA™ Energy Recovery 50HJ004-007 Units with 62AQ060) (cont)

					HEATER	HEAT		POWER SUPPLY				SINGLE	DISCONNECT SIZE*
UNIT	NOMINAL	IFM	CONV	62AQ	CRHEATER				FUSE OR			POINT BOX
	V-PH-Hz	TYPE	OUTLET	FLA		FLA	MCA			MOCP		CRSINGLE	FLA	LRA
					---A00				HACR BKR
												---A00
					NONE	—	20.1		25	—		—	20	110
					006	7.2	20.1		25	—		—	20	111
		HIGH STATIC	NO	9.2	008	13.8	26.2		30	—		—	20	111
					009	16.8	29.9		30	—		—	29	111
50HJ006					008+008	27.7	43.5		45	—		025	41	111
	460-3-60				008+009	30.7	47.2		50	—		025	44	111
(cont)					NONE	—	22.8		25	—		—	26	115
					006	7.2	22.8		25	—		—	26	116
		HIGH STATIC	YES	9.2	008	13.8	28.3		30	—		—	26	116
					009	16.8	32.0		35	—		025	33	116
					008+008	27.7	45.6		50	—		025	46	116
					008+009	30.7	49.3		50	—		025	49	116
					NONE	—/—	42.0/ 42.0		50/50	—		—	42/42	234/234
					002	13.6/15.6	42.0/	42.0	50/50	—		—	42/42	234/234
		STD	NO	9.2	004	21.9/25.3	44.1/	48.3	50/50	—		—	42/46	234/234
					005	33.4/38.5	58.4/	64.9	—	60/	70	002	56/62	234/234
					004+004	43.8/50.5	71.5/	79.9	—	80/	80	003	68/75	234/234
					004+005	55.2/63.8	85.8/	96.4	—	90/100		003	81/91	234/234
					NONE	—/—	48.0/ 48.0		60/60	—		—	48/48	239/239
					002	13.6/15.6	48.0/	48.0	60/60	—		—	48/48	239/239
		STD	YES	9.2	004	21.9/25.3	48.9/	52.5	60/60	—		—	48/51	239/239
					005	33.4/38.5	63.2/	69.1	—	70/	70	003	61/66	239/239
					004+004	43.8/50.5	76.3/	84.1	—	80/	90	003	73/80	239/239
	208/230-3-60				004+005	55.2/63.8	90.6/100.6		—	100/110		003	86/95	239/239
					NONE	—/—	43.7/ 43.7		50/50	—		—	44/44	253/253
					002	13.6/15.6	43.7/	43.7	50/50	—		—	44/44	253/253
		HIGH STATIC	NO	9.2	004	21.9/25.3	45.9/	50.1	50/60	—		—	44/48	253/253
					005	33.4/38.5	60.3/	66.7	—	70/	70	003	58/63	253/253
					004+004	43.8/50.5	73.3/	81.7	—	80/	90	003	70/77	253/253
					004+005	55.2/63.8	87.6/	98.3	—	90/100		003	83/93	253/253
					NONE	—/—	49.7/ 49.7		60/60	—		—	50/50	258/258
					002	13.6/15.6	49.7/	49.7	60/60	—		—	50/50	258/258
		HIGH STATIC	YES	9.2	004	21.9/25.3	50.7/	54.3	60/60	—		—	50/53	258/258
					005	33.4/38.5	65.1/	70.9	—	70/	80	003	63/68	258/258
					004+004	43.8/50.5	78.1/	85.9	—	80/	90	003	75/82	258/258
50HJ007					004+005	55.2/63.8	92.4/102.5		—	100/110		003	88/97	258/258
					NONE	—	19.8		25	—		—	20	114
					006	7.2	19.8		25	—		—	20	114
		STD	NO	9.2	008	13.8	25.4		30	—		—	20	114
					009	16.8	29.1		30	—		—	28	114
					008+008	27.7	42.7		45	—		025	40	114
					008+009	30.7	46.4		50	—		025	44	114
					NONE	—	22.5		25	—		—	26	118
					006	7.2	22.5		25	—		—	26	119
		STD	YES	9.2	008	13.8	27.5		30	—		—	26	119
					009	16.8	31.2		35	—		025	32	119
					008+008	27.7	44.8		45	—		025	45	119
	460-3-60				008+009	30.7	48.5		50	—		025	48	119
					NONE	—	20.6		25	—		—	21	123
					006	7.2	20.6		25	—		—	21	124
		HIGH STATIC	NO	9.2	008	13.8	26.2		30	—		—	21	124
					009	16.8	29.9		30	—		—	29	124
					008+008	27.7	43.5		45	—		025	41	124
					008+009	30.7	47.2		50	—		025	44	124
					NONE	—	23.3		30	—		—	26	128
					006	7.2	23.3		30	—		—	26	128
		HIGH STATIC	YES	9.2	008	13.8	28.3		30	—		—	26	128
					009	16.8	32.0		35	—		025	33	128
					008+008	27.7	45.6		50	—		025	46	128
					008+009	30.7	49.3		50	—		025	49	128

	LEGEND
FLA	— Full Load Amps
HACR	— Heating, Air Conditioning and Refrigeration
IFM	— Indoor (Evaporator) Fan Motor
LRA	— Locked Rotor Amps
MCA	— Minimum Circuit Amps
MOCP — Maximum Overcurrent Protection
NEC	— National Electrical Code
UL	— Underwriters’ Laboratories

*Used to determine minimum disconnect per NEC.

†Single point box CRSINGLE017A00 is part of base unit.

NOTES:

1.In compliance with NEC requirements for multimotor and combination load equipment (refer to NEC Articles 430 and 440), the overcurrent protective device for the unit shall be fuse or HACR breaker. UL, Canada units may be fuse or cir- cuit breaker.

2.Unbalanced 3-Phase Supply Voltage

Never operate a motor where a phase imbalance in supply voltage is greater than 2%. Use the following formula to determine the percent of voltage imbalance.

max voltage deviation from average voltage

= 100 x

average voltage

Example: Supply voltage is 460-3-60.

AB = 452 v

BC = 464 v

AC = 455 v

452 + 464 + 455

Average Voltage =

3

1371

=

3

=457

Determine maximum deviation from average voltage. (AB) 457 – 452 = 5 v

(BC) 464 – 457 = 7 v (AC) 457 – 455 = 2 v Maximum deviation is 7 v.

Determine percent of voltage imbalance.

% Voltage Imbalance = 100 x	7
	457
= 1.53%

This amount of phase imbalance is satisfactory as it is below the maximum allow- able 2%.

IMPORTANT: If the supply voltage phase imbalance is more than 2%, contact your local electric utility company immediately.

16