Pelco Not ICS110-CW manual Voltage, Red Wire, Black Wire, Adapter Plate

6. Connect the power wires.

Voltage	Red Wire	Black Wire
12 VDC	+	Ground
24 VAC	~	~

AC operation only: If you are wiring more than one Camclosure integrated camera system to the same transformer, connect one side of the transformer to the red wire on all units, and connect the other side of the transformer to the black wire on all units. Failure to connect all of the units the same way will cause the cameras to be out of phase with each other and may produce a vertical roll when switching between cameras.

7. Reinstall the back box inside the cover. For vandal-resistant installations, rotate the back box to position the conduit plug opposite the notch on the side of the cover. Use the two

8-32 x 0.375-inch Phillips pan head screws and washers (removed earlier) to secure the back box to the cover.

4S STANDARD ELECTRICAL BOX

CEILING/

WALL

8-32 X 0.75-INCH	ADAPTER PLATE
PHILLIPS FLAT
HEAD SCREWS	(ICS110-AP)
(SUPPLIED)

COVER

8-32 X 0.375-INCH

PHILLIPS PAN HEAD SCREWS (SUPPLIED WITH ICS110-AP)

BACK BOX

8-32 X 0.375-INCH PHILLIPS PAN HEAD SCREWS WITH WASHERS (SUPPLIED)

Figure 3. 4S Electrical Box Installation

10 C3406M-D (1/07)