4S ELECTRICAL BOX INSTALLATION

8.Reinstall the back box inside the cover. For vandal-resistant installations, rotate the back box to position the conduit plug opposite the notch on the side of the cover. Use the two

8-32 x 0.375-inch Phillips pan head screws and washers (removed earlier) to secure the back box to the cover.

COVER

MOUNTING SCREWS (NOT SUPPLIED)

BACK BOX

8-32 X 0.375-INCH PHILLIPS PAN HEAD SCREWS WITH WASHERS (SUPPLIED)

Figure 2. Basic Surface Installation

NOTE: You should install the camera module into the back box before installing the back box into the cover. When installing the back box into the cover, rotate the camera module to access the mounting holes. Refer to Camera Module for more information.

1.Attach an ICS110-AP adapter plate (not supplied) to a 4S box. Use two 8-32 x 0.75-inch Phillips ﬂat head screws (supplied with both the ICS110 and the adapter plate).

2.Remove the two 8-32 x 0.375-inch Phillips pan head screws and washers to separate the cover from the back box.

3.Pull the video and power wires into the cover.

4.Attach the cover to the adapter plate with up to four 8-32 x 0.375-inch Phillips pan head screws (supplied with the adapter plate). Use stainless steel hardware when installing the system outdoors.

5.Connect the video cable/wires:

BNC: Connect the BNC connector from the unit to a mating BNC connector.

Twisted Pair (UTP): Blue wire = Video +

Gray wire = Video -

C3406M-D (1/07)