SWITCH SETTINGS
Locate the DIP switch (refer to Figure 10). Then set the switches for your installation.
DIP SWITCH
DOWN UP 
1 2 3 4 5 6
ON
SWITCH POSITION
Figure 10. DIP Switch
SW1: Video Format
Set to ON for NTSC. Set to OFF for PAL. The default is ON.
SW2: Line Sync
Set to ON to use AC line lock. Set to OFF for internal line sync. The default is ON.
SW3: Interlaced Scanning/Progressive Scanning
Set to ON to select interlaced scanning. Set to OFF to select progressive scanning. The default is ON.
SW4: Auto White Balance (AWB)/Auto Tracking White Balance (ATW)
Set to ON to enable ATW. This is the default.
To manually set and lock the white balance (AWB), power up the unit. Then place a white background in front of the lens and turn SW4 to OFF.
SW5/SW6: Profile
Select the preset profile that best matches your installation:
Profile | Minimum | SW5 | SW6 | |
Illumination | ||||
|
|
| ||
General (default) | 6.0 lux | ON | ON | |
Extended shutter | 0.5 lux (15 fps) | OFF | ON | |
Extended dynamic range | 3.0 lux | ON | OFF | |
Fluorescent | 3.0 lux | OFF | OFF |
General (default): Use for most installations. This profile provides very good general image quality.
Extended shutter: Use for installation that are mostly low light.
18 |