Pelco Not ICS110-CW manual Twisted Pair UTP Blue wire = Video +, Voltage, Red Wire

7.Install a 0.75-inch (1.91 cm) threaded conduit connector (not supplied) into the conduit hole in the back box.

COVER

0.75-INCH CONDUIT

CONNECTOR

BACK BOX

REMOVE

CONDUIT PLUG

8-32 X 0.375-INCH PHILLIPS PAN HEAD SCREWS WITH WASHERS (SUPPLIED)

Figure 5. Side Conduit Installation

8.Connect the video cable/wires:

BNC: Connect the BNC connector from the unit to a mating BNC connector.

Twisted Pair (UTP): Blue wire = Video +

Gray wire = Video -

9. Connect the power wires.

Voltage	Red Wire	Black Wire
12 VDC	+	Ground
24 VAC	~	~

AC operation only: If you are wiring more than one Camclosure integrated camera system to the same transformer, connect one side of the transformer to the red wire on all units, and connect the other side of the transformer to the black wire on all units. Failure to connect all of the units the same way will cause the cameras to be out of phase with each other and may produce a vertical roll when switching between cameras.

C3406M-D (1/07) 13