CAMERA ORIENTATION
At the factory, the camera module is configured for ceiling mounting. For wall mounting, you must change the camera orientation or the video image will be upside down.
To change the camera orientation (refer to Figure 8):
1.Remove the camera module from the back box if necessary.
2.Remove the tilt adjustment screw and lock washer from each side of the camera.
3.Carefully rotate the camera one half turn. Make sure the wiring harness does not bind.
4.Reinstall the tilt adjustment screw and lock washer on each side of the camera.
5.Verify the camera orientation.
CEILING MOUNT (DEFAULT) | WALL MOUNT |
BOTTOM | TOP OF |
OF CAMERA | CAMERA |
TILT ADJUSTMENT | TILT ADJUSTMENT |
SCREW AND | SCREW AND |
LOCK WASHER | LOCK WASHER |
Figure 8. Camera Orientation
MODULE INSTALLATION
To install the camera module into the back box:
1.Plug the camera
2.Make sure the tabs on the camera bracket and the service connector are pointing out of the enclosure, away from the ceiling or wall.
3.Gently squeeze the bracket, place it against the groove inside back box, and gently release (refer to Figure 6 on page 14).
16 |