Pelco 2 C1306M-B (10/06) manual 239

Page 11

Table B. D Protocol Receiver Address (Continued)

				SWITCH SETTING
				SWITCH SETTING
ADDRESS	SW1-1	SW1-2	SW1-3	SW1-4 SW1-5		SW1-6	SW1-7	SW1-8
239	ON	ON	ON	ON	OFF	ON	ON	ON

240	OFF	OFF	OFF	OFF	ON	ON	ON	ON
241	ON	OFF	OFF	OFF	ON	ON	ON	ON

242	OFF	ON	OFF	OFF	ON	ON	ON	ON
243	ON	ON	OFF	OFF	ON	ON	ON	ON

244	OFF	OFF	ON	OFF	ON	ON	ON	ON
245	ON	OFF	ON	OFF	ON	ON	ON	ON

246	OFF	ON	ON	OFF	ON	ON	ON	ON

				SWITCH SETTING
ADDRESS	SW1-1 SW1-2		SW1-3	SW1-4 SW1-5		SW1-6	SW1-7 SW1-8
247	ON	ON	ON	OFF	ON	ON	ON	ON

248	OFF	OFF	OFF	ON	ON	ON	ON	ON
249	ON	OFF	OFF	ON	ON	ON	ON	ON

250	OFF	ON	OFF	ON	ON	ON	ON	ON
251	ON	ON	OFF	ON	ON	ON	ON	ON

252	OFF	OFF	ON	ON	ON	ON	ON	ON
253	ON	OFF	ON	ON	ON	ON	ON	ON

254	OFF	ON	ON	ON	ON	ON	ON	ON

C1306M-B (10/06)

11

Image 11

Contents ExSite Ehxm Series Explosionproof Fixed System List of Tables ContentsList of Illustrations Important Safety Instructions Getting Started Methods of InstallationAttach Power Module to Mounting Surface Install the Power ModuleConfiguration of Wire Harness Connect WiringProtocol Settings DIP Switch SettingsOn next Address SW1-2 SW1-3 SW1-4 SW1-5 SW1-6 SW1-7 239 Remove Back Cap of Camera Enclosure Install the Camera ModuleInstall Camera Module SET TAB Center Position Factory-Installed Power Module Seal Install the Enclosure and Set Pan PositionSet the Tilt Angle of the Camera Module Install the Sun Shroud Install the Sun ShroudCamera Module Replacement MaintenanceInstall Camera Module C1306M-B 10/06 Electrical SpecificationsCamera Day/Night 23X Color LowLight 22X Color CAMERA/OPTICSProduct Warranty and Return Information ISO9001