Pelco 2 C1306M-B (10/06) manual Install the Sun Shroud

Page 17

Install the Sun Shroud

1.Place the supplied nylon washers on the 6-32 Phillips pan head screws. Refer to Figure 12.

2.Align the mounting holes of the sun shroud with the holes on top of the camera enclosure.

3.Use the supplied nylon washers and screws to secure the sun shroud to the camera enclosure.

NYLON

6-32 PHILLIPS PAN WASHER HEAD SCREW

SUN SHROUD

Figure 12. Install the Sun Shroud

C1306M-B (10/06)

17

Image 17

Contents ExSite Ehxm Series Explosionproof Fixed System List of Tables ContentsList of Illustrations Important Safety Instructions Getting Started Methods of InstallationAttach Power Module to Mounting Surface Install the Power ModuleConfiguration of Wire Harness Connect WiringProtocol Settings DIP Switch SettingsOn next Address SW1-2 SW1-3 SW1-4 SW1-5 SW1-6 SW1-7 239 Remove Back Cap of Camera Enclosure Install the Camera ModuleInstall Camera Module SET TAB Center Position Factory-Installed Power Module Seal Install the Enclosure and Set Pan PositionSet the Tilt Angle of the Camera Module Install the Sun Shroud Install the Sun ShroudCamera Module Replacement MaintenanceInstall Camera Module C1306M-B 10/06 Electrical SpecificationsCamera Day/Night 23X Color LowLight 22X Color CAMERA/OPTICSProduct Warranty and Return Information ISO9001