Pelco 2 C1306M-B (10/06) manual C1306M-B 10/06

Page 20

6.Models with a wiper: Refer to Figure 14 and do the following to reinstall the arm of the wiper:

a.Reinstall the green bushing on the stud located behind the handle of the camera module.

b.Reinstall the wiper arm. Place the ridge of the arm in the notch of the camera enclosure tab and the slot of the arm over the green bushing.

7.Secure the camera module and the wiper arm with the 8-32 Phillips flat head screw (refer to Figure 14).

WARNINGS:

To avoid thread damage, carefully install the back cap to the enclosure.

Never force the back cap onto the end of the enclosure.

When installation is completed, there should be no gap between the back cap and the camera enclosure.

8.Reinstall the back cap on the camera enclosure by doing the following:

a.Use your hands to turn the back cap clockwise until you can no longer turn it with your hands. The back cap should turn easily until it comes in contact with the O-ring. If it does not turn easily, the threads are not aligned and thread damage will occur.

b.Continue tightening the back cap with the supplied spanner wrench. There should be no gap between the back cap and the camera enclosure when the back cap is tightened and properly installed.

c.After the back cap is installed, secure the back cap with the set screw using a 1.5 mm Allen wrench.

20

C1306M-B (10/06)

Image 20
Contents ExSite Ehxm Series Explosionproof Fixed System List of Tables ContentsList of Illustrations Important Safety Instructions Methods of Installation Getting StartedInstall the Power Module Attach Power Module to Mounting SurfaceConnect Wiring Configuration of Wire HarnessDIP Switch Settings Protocol SettingsOn next Address SW1-2 SW1-3 SW1-4 SW1-5 SW1-6 SW1-7 239 Install the Camera Module Remove Back Cap of Camera EnclosureInstall Camera Module SET TAB Center Position Install the Enclosure and Set Pan Position Factory-Installed Power Module SealSet the Tilt Angle of the Camera Module Install the Sun Shroud Install the Sun ShroudMaintenance Camera Module ReplacementInstall Camera Module C1306M-B 10/06 Specifications ElectricalCAMERA/OPTICS Camera Day/Night 23X Color LowLight 22X ColorProduct Warranty and Return Information ISO9001