ECP190 DOOR CONTROLLER with
KEYPAD ACCESS CODE CONTROL
TOP POINTS TO REMEMBER
■Programming is effected directly via the keypad.
■Master Code (Programming Access Code) is always a 5 digit number.
■Master Code is always stored in Slot No. 06.
■Keypad Access Codes are always 5 digit numbers.
■Keypad Access Codes can be stored in Slot Nos. 03 - 05 and 07 - 30 only.
SET-UP ON INSTALLATION
Proceed exactly as detailed before in section ECP Door Controller with Access Pass Control. Stop when you have completed Step 3. Then - Turn off programming switch SW1 in the Door Controller.
PROGRAMMING KEYPAD ACCESS CODES
Keypad Access Codes must be 5 digits in length and can only be stored in Slot Numbers
Example: You want to program codes: | 46296 | for Alan |
| 78327 | for Tony |
| 32534 | for Alex |
Enter the Master Code on the keypad:
Beeps every 4 seconds indicate that you have accessed Programming Mode.
After a beep enter on the keypad:
A sharp beep confirms that Alan’s code is recorded. Programming mode beep - every 4 seconds - resumes.
After a beep enter on the keypad:
A sharp beep confirms that Tony’s code is recorded. Programming mode beep - every 4 seconds - resumes.
After a beep enter on the keypad:
A sharp beep confirms that Alex’s code is recorded. Programming mode beep - every 4 seconds - resumes.
Note Carefully:
Never program a keypad access code into Slot Numbers 01, 02 or 06.
DELETING KEYPAD ACCESS CODES |
|
|
|
Example: You want to delete Alan’s code | 46296 | which is stored in Slot No. 03 | |
You want to delete Alex’s code | 32534 | which is stored in Slot No. 07 | |
Enter the Master Code on the keypad:
Beeps every 4 seconds indicate that you have accessed Programming Mode.
18