Programming using TELPRO™ as a remote wire-free programmer.
Remote Programming Range:
20 cms - 5 metres | |
Proximity Reader | 5 cms - 10 cms |
How to use the TELPRO: |
|
Important:
Each press of a button is confirmed (as received) by the reader/receiver by a single beep. Press the TELPRO™ buttons gently.
Flick TELPRO switch to ON - Red LED on the right must light up.
(Remember to turn unit off when finished)
Point TELPRO at the reader/receiver.
Dimensions (mm): 120L x 60W x 25D
Enter the Master Code and wait for the reader/receiver to start beeping every 4 seconds
OR
Flick Programming Switch SW1 and wait for the reader/receiver to start beeping every 4 seconds (Remember to turn off the programming switch SW1 when you have finished programming).
Follow programming instructions
Note: An incorrect programming operation is signalled by a series of 3 beeps.
Programming using TELPRO™ as a hard-wired programmer
How to use the TELPRO as a hard wired unit:
Insert the jack connection into the top of the TELPRO unit.
Plug the connector terminal onto J5 on ECP Door Controller.
Enter the Master Code and wait for the unit
to start beeping every 4 seconds
OR
Flick Programming Switch SW1 and wait for the unit
to start beeping every 4 seconds
(Remember to turn off the programming switch SW1
when you have finished programming)
Follow programming instructions.
ECP290/ECP200
J5 = Access Point 1
J6 = Access Point 2
Important:
Each press of a button is confirmed (as received) by the Door Controller by a single beep.
Press the TELPRO™ buttons gently.
8