SkyLink 91558-01A, 91561-01, 91562-01 service manual General, FCC Notices

Page 1

-J02028

REV. 2010-09-07

REMOTE CONTROL GARAGE DOOR OPENER KITS

GENERAL

Kit Numbers

91558-01A (Transmitter/Receiver Kit), 91561-01 (Transmitter Kit), 91562-01 (Receiver Kit)

Models

For model fitment information, see the P&A retail catalog or the Parts and Accessories section of www.harley-davidson.com (English only).

Additional Parts Required

2011 and later Softail models will require separate purchase of an Electrical Connection Harness (Part No. 72673-11).

Tools and Supplies Required

Electrical Contact Lube (Part No. 99861-02) or equivalent is required after battery cable disconnection.This item is available from a Harley-Davidson dealer.

The rider's safety depends upon the correct installation of this kit. Use the appropriate service manual procedures. If the procedure is not within your capabilities or you do not have the correct tools, have a Harley-Davidson dealer perform the installation. Improper installation of this kit could result in death or serious injury. (00333a)

NOTE

This instruction sheet refers to service manual information. A service manual for this year/model motorcycle is required for this installation and is available from a Harley-Davidson dealer.

Electrical Overload

It is possible to overload your vehicle's charging system by adding too many electrical accessories. If the combined electrical accessories operating at any one time consume more electrical current than the vehicle's charging system can produce, the electrical consumption can discharge the battery and cause damage to the vehicle's electrical system. See an authorized Harley-Davidson dealer for advice about the amount of current consumed by addi- tional electrical accessories or for necessary wiring changes. (00211c)

When installing any electrical accessory, be certain not to exceed the maximum amperage rating of the fuse or circuit breaker protecting the affected circuit being modi- fied. Exceeding the maximum amperage can lead to elec- trical failures, which could result in death or serious injury. (00310a)

The Remote Control Transmitter in kits 91558-01A and 91561- 01 requires up to 0.5 Amps additional current from the electrical system.

Kit Contents

See Figure 27, Table 1, Table 2 and Table 3.

FCC NOTICES

NOTE

Changes or modifications to this unit not expressly approved by the manufacturer could void the user's authority to operate the equipment.

This equipment has been tested and found to comply with the limits for Class B digital devices pursuant to Part 15, Subpart B of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a resid- ential environment. This equipment generates, uses, and can radiate radio-frequency energy, and if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation.

If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

•Re-orient or relocate the receiving antenna.

•Increase the distance between the equipment and the receiver.

•Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.

•Consult the dealer or an experienced radio/TV technician for help.

-J02028

1 of 16

Page 1 Page 2
Image 1
Page 1 Page 2
Contents FCC Notices GeneralVehicle Preparation Receiver InstallationFor Dyna, Softail and Sportster models Transmitter InstallationDyna Models Earlier SoftailsLater Softail Deuce Fxstd Later Softails, Except Deuce FxstdSportster Models Rear wheel and tire Rear fork TransmitterFlhr Touring Models Later Sportster ModelsFLHT, Flhx and Fltr Touring ModelsTrike Models Rod Models Transmitter Fuse block wire harnessLater V-Rod Models Louvered cover Tab ScrewGeneral Harness ConnectionLater Softail Models Touring and Trike ModelsEarlier Softail Models Black Lead Connection to GroundInto 1 splice Ground screws black wire ORANGE/WHITE Lead Connection to Switched Power SourceEarlier Dyna Models Later Dyna ModelsSoftail Models Fuse Block Adapter Wire Dyna and SoftailWire Splice Locations 2002-2003 V-Rod Power Connections Sportster ModelsYellow Andwhite Lead Connections to Headlamp Wire Splice Locations 2005 and Later V-RodIs06727 Reset the Receiver TroubleshootingNO. Proceed to Reset the Receiver Receiver and Transmitter ProgrammingService Parts Not sold separately

91562-01, 91558-01A, 91561-01 specifications

SkyLink has made a remarkable entry into the realm of wireless communication devices with its innovative models: the SkyLink 91562-01, 91558-01A, and 91561-01. Each of these devices is tailored to meet the demands of modern security systems, providing reliability and efficiency for both residential and commercial applications.

The SkyLink 91562-01 stands out for its versatility and ease of use. This wireless communication hub can connect with multiple sensors and devices, enabling a comprehensive security system. Featuring advanced encryption technology, it ensures that communications between the hub and connected devices remain secure from unauthorized access. The 91562-01 supports DIY installation, which means users can easily set up their system without needing professional assistance. Additionally, its sleek design allows it to blend seamlessly into any home decor.

Next, the SkyLink 91558-01A is engineered to provide enhanced connectivity and communication. It features long-range capabilities, allowing it to cover expansive areas without losing signal strength. This model is compatible with a variety of SkyLink sensors and accessories, enabling users to customize their security system according to their specific needs. The 91558-01A is equipped with a built-in backup battery, ensuring that the system remains operational even during power outages, a crucial feature for maintaining security integrity.

Finally, the SkyLink 91561-01 is particularly suited for users who prioritize ease of access and monitoring. With its user-friendly interface, it allows users to manage their security settings and receive real-time alerts from anywhere using a mobile app. This model supports remote access, adding a layer of convenience for those on the go. Moreover, the 91561-01 integrates with smart home devices, providing a holistic approach to home automation and security.

In summary, the SkyLink 91562-01, 91558-01A, and 91561-01 represent a convergence of technology, security, and user-friendliness. With features like long-range communication, innovative encryption, and mobile connectivity, these devices are designed to cater to the dynamic needs of users, ensuring safety and peace of mind in an increasingly connected world. Each model brings its set of strengths to the table, making them suitable for a wide range of applications and user preferences. SkyLink continues to push the envelope in wireless communication and security technology, solidifying its position as a leader in the industry.
Top Page Image Contents