PYLE Audio PLCD20CH manual Wiring - FM Modulator unit, Interference on 89.1 MHz

Wiring — FM Modulator unit

RF output (89.1MHz or 88.7 MHz)

Antenna socket

To + 12V ACC. Speaker

FM Radio

To car antenna

FM

Modulator

ACC/Ignition power lead (red)

Fuse 0.5A Connect to where the power is supplied when the ACC power or ignition switch is turned ON.

Fuse 5ABattery power lead (pink)

Memory back up. To be connected to continuous power source.

Ground lead (black)

Screw this to a metal part of the vehicle.

DIN connection cord (6-pin)	Commander
	SELECT SCAN REPEAT RANDOM
	RESETDISC
CD Changer	OFF
	TRK/SKIP

Interference on 89.1 MHz

•If a clear signal cannot be obtained on 89.1 MHz, change the position of the frequency select switch on the back of the FM Modulator and tune the radio to 88.7 MHz when using the CD changer.

•Select a frequency before mounting the FM Modulator. Radio sensitivity is slightly reduced when the FM Modulator is connected.

•RESET SWITCH

A reset switch is located at the bottom of the FM modulator can only activated by a thin pointed object when:

1.After all the wiring installation completed.

2.If abnormal disc operation occurs.

20