PYLE Audio PLCD20CH manual Installation

INSTALLATION

Procedure for Installation on Carpet (Horizontal Position)

1

•Confirm that the built-in anti-vibration boards on both the left and right sides are set to the horizontal installation position “0”.

•Attach the left and right brackets (A) using the hexagonal bolt (M4 x 5).

•Attach the left and right brackets (A) to their respective brackets (B) using the hexagonal bolts (M6 x 12) and the hexagonal nuts (M6).

Built-in anti-vibration board position

Hexagon bolts (M6 x 12)

				Hexagonal
				bolts
				(M4 x 5)
2	•	Pull back the carpet and determine	3	• Remove the hexagonal nuts and
		where to attach the unit.		take off the changer.
	•	Stick the supplied double-sided
		tape to the bottom of the brackets
		(B) and peel off the paper backing.
	•	Affix the unit to the floor by pressing
		in place.

4	• Using a knife, cut “X”s in the carpet	5	• Once more, use the hexagonal nuts
	directly above the brackets (B) bolts.		to attach the changer on top of the
			carpet.

•Return the carpet to its original

position allowing the bolts to stick through.

8