PYLE Audio PLCD20CH manual Precautions For Handling Discs, With new discs

Page 4
PRECAUTIONS FOR HANDLING DISCS

PRECAUTIONS FOR HANDLING DISCS

 With new discsManual background With new discs

The symptoms described below sometimes occur when new discs are used:

• The disc is not played even

Burrs

when it is loaded.

Center

• Operation changes to the next

disc before the first disc has a

Burrs hole

chance to be played.

Outside

• The same disc is played over

circmference

and over again.

 

• The designated disc is not

 

played.

 

These symptoms occur when there are burrs on the center hole or outside circumference of the disc and, as a result, the disc has not been loaded properly or the disc catches on something inside the magazine. In cases like these remove the burrs using a ball point pen or similar implement, as shown in the figure on the right.

Remove all plastic particles of burr from surfaces of disc before loading in magazine.

WARNING

Manual backgroundManual background Although protective film is being marketed as CD accessories, use of these products will result in malfunctions and should absolutely be avoided.

4

Image 4
Contents OPERATING INSTRUCTIONS Compact Disc Auto ChangerPLCD20CH Disc MagazineCONTENTS HINTS FOR CORRECT AND SAFE OPERATIONInstalling the magazine HOW TO USE THE MAGAZINELoading a disc PRECAUTIONS FOR HANDLING DISCS With new discsINSTALLATION PARTS WIRINGRESET FUNCTION Some functions do not operate Reset buttonInstallation and Wiring Precautions BEFORE INSTALLING THE UNITTransport Lock Screws For use when unit is installed at a 45 angle For use when unit is installed verticallyPosition of the built-in anti-vibrationboard INSTALLATION Pull back the carpet and determine Set the built-in anti-vibrationboards Procedure for Installation Suspended Position TROUBLESHOOTING SymptomHANDLING THE DISCS CauseCD Changer Remote Control System RESETDISCOPERATING INSTRUCTIONS SELECT SCAN REPEAT RANDOMPARTS AND THEIR FUNCTIONS Control sectionLiquid Crystal Display LCD Select ButtonPower Button Power On/Off Random Play Button Track or DISC RandomPlay/Pause Button Play/Pause Disc Selection Button +Reset Button Reset buttonBEFORE USING THE SYSTEM SETTING UP FOR OPERATIONWiring - Using FM Modulator Power ON and PlayCD CHANGER OPERATION Listening to the CD PlayPlaying in Other Modes Playing a CDInstallation of the FM Modulator/Ground Isolator Procedure To Mount The CD Changer Commander unitListening to the radio or tape Random playWiring - FM Modulator unit Interference on 89.1 MHzControl and Function Keys 1.+12V TO IGNITION2.ANTENNA 3.GROUND - /BACK UP5.RESET FOR MODULATOR FUNCTION ONLY 7.CD CHANGER COMMANDER4.OUTPUT FREQUENCY 6.CD CHANGERError Messages showing on display of controller TROUBLESHOOTINGSymptom Cause88-D0040-14