PYLE Audio PLCD20CH manual Installation Parts, Wiring, Reset Function, CD player

Page 5

INSTALLATION PARTS

Bracket (A)	Bracket (B)	Hexagonal Bolt	Truss Screw
		(M6 x 12)	(M4 x 5)

x 2	x 2	x 4	x 4
Tapping Screw	DIN 8	Seal	Double
(M5 x 12)	Pin Cable		Sided Tape

x 4

x 1

x 2

WIRING

Connect this cable to the terminal of the

CD player.

RESET FUNCTION

The reset button must be activated with either a ball point pen or thin metal object. It is to be activated for the following reason:

• Initial installation of the unit when all wiring is completed.

• Some functions do not operate.

Reset button

Image 5

Contents Compact Disc Auto Changer OPERATING INSTRUCTIONSPLCD20CH Disc MagazineHINTS FOR CORRECT AND SAFE OPERATION CONTENTSLoading a disc HOW TO USE THE MAGAZINEInstalling the magazine With new discs PRECAUTIONS FOR HANDLING DISCSWIRING INSTALLATION PARTSRESET FUNCTION Some functions do not operate Reset buttonTransport Lock Screws BEFORE INSTALLING THE UNITInstallation and Wiring Precautions Position of the built-in anti-vibrationboard For use when unit is installed verticallyFor use when unit is installed at a 45 angle INSTALLATION Pull back the carpet and determine Set the built-in anti-vibrationboards Procedure for Installation Suspended Position Symptom TROUBLESHOOTINGHANDLING THE DISCS CauseRESETDISC CD Changer Remote Control SystemOPERATING INSTRUCTIONS SELECT SCAN REPEAT RANDOMControl section PARTS AND THEIR FUNCTIONSLiquid Crystal Display LCD Select ButtonRandom Play Button Track or DISC Random Power Button Power On/OffPlay/Pause Button Play/Pause Disc Selection Button +Reset button Reset ButtonSETTING UP FOR OPERATION BEFORE USING THE SYSTEMWiring - Using FM Modulator Power ON and PlayListening to the CD Play CD CHANGER OPERATIONPlaying in Other Modes Playing a CDProcedure To Mount The CD Changer Commander unit Installation of the FM Modulator/Ground IsolatorListening to the radio or tape Random playInterference on 89.1 MHz Wiring - FM Modulator unit1.+12V TO IGNITION Control and Function Keys2.ANTENNA 3.GROUND - /BACK UP7.CD CHANGER COMMANDER 5.RESET FOR MODULATOR FUNCTION ONLY4.OUTPUT FREQUENCY 6.CD CHANGERTROUBLESHOOTING Error Messages showing on display of controllerSymptom Cause88-D0040-14