PYLE Audio PLCD20CH manual Contents, Hints For Correct And Safe Operation

Page 2
CONTENTS

CONTENTS

HINTS FOR CORRECT AND SAFE OPERATION

2

HOW TO USE THE MAGAZINE

3

PRECAUTIONS FOR HANDLING DISCS

4

INSTALLATION PARTS

5

WIRING

5

RESET FUNCTION

5

BEFORE INSTALLING THE UNIT

6

• Transport Lock Screws

6

• Installation and Wiring Precautions

6

• Position of the built-in anti-vibration Board

7

INSTALLATION

8

• Procedure for Installation on Carpet (Horizontal Position)

8

• Procedure for Installation on Carpet (Vertical Position)

9

• Procedure for Installation on Carpet (At a 45° angle)

10

• Procedure for Installation (Suspended Position)

11

HANDLING THE DISCS

12

TROUBLE SHOOTING

12

CD CHANGER REMOTE CONTROL SYSTEM

13 - 23

HINTS FOR CORRECT AND SAFE OPERATION

This CD Changer is designed to be operated only on +12 volt DC negative ground systems. The unit cannot be used on +24 volt or positive ground systems.

The unit may not operate correctly in extremely hot or cold temperatures. The unit is equipped with a built in self-protection circuit. When the temperature reaches a preset level, the protection circuit halts all unit operations. If this should happen, open a window and allow the car to cool.

Condensation

Moisture can condense on the laser lens of the CD changer during rainy and humid days, or right after the heater is turned on in the car. If this should happen the unit will not operate correctly. To remedy the situation, remove the magazine from the unit and wait approximately one hour. During this time the moisture will evaporate and the unit will operate normally.

Remove the magazine from the unit when it is not being used during hot weather and the CD changer is not used for long periods of time.

2

Page 1 Page 3
Image 2
Page 1 Page 3
Contents PLCD20CH OPERATING INSTRUCTIONSCompact Disc Auto Changer Disc MagazineCONTENTS HINTS FOR CORRECT AND SAFE OPERATIONLoading a disc HOW TO USE THE MAGAZINEInstalling the magazine PRECAUTIONS FOR HANDLING DISCS With new discsRESET FUNCTION INSTALLATION PARTSWIRING Some functions do not operate Reset buttonTransport Lock Screws BEFORE INSTALLING THE UNITInstallation and Wiring Precautions Position of the built-in anti-vibrationboard For use when unit is installed verticallyFor use when unit is installed at a 45 angle INSTALLATION Pull back the carpet and determine Set the built-in anti-vibrationboards Procedure for Installation Suspended Position HANDLING THE DISCS TROUBLESHOOTINGSymptom CauseOPERATING INSTRUCTIONS CD Changer Remote Control SystemRESETDISC SELECT SCAN REPEAT RANDOMLiquid Crystal Display LCD PARTS AND THEIR FUNCTIONSControl section Select ButtonPlay/Pause Button Play/Pause Power Button Power On/OffRandom Play Button Track or DISC Random Disc Selection Button +Reset Button Reset buttonWiring - Using FM Modulator BEFORE USING THE SYSTEMSETTING UP FOR OPERATION Power ON and PlayPlaying in Other Modes CD CHANGER OPERATIONListening to the CD Play Playing a CDListening to the radio or tape Installation of the FM Modulator/Ground IsolatorProcedure To Mount The CD Changer Commander unit Random playWiring - FM Modulator unit Interference on 89.1 MHz2.ANTENNA Control and Function Keys1.+12V TO IGNITION 3.GROUND - /BACK UP4.OUTPUT FREQUENCY 5.RESET FOR MODULATOR FUNCTION ONLY7.CD CHANGER COMMANDER 6.CD CHANGERSymptom Error Messages showing on display of controllerTROUBLESHOOTING Cause88-D0040-14
Top Page Image Contents