INSTALLATION INSTRUCTIONS
INSTALLATION
IMPORTANT: BEFORE THE APPLIANCE CAN BE OPERATED THE REMOTE HANDSET MUST BE TUNED TO THE CONTROL BOX SITUATED UNDER THE APPLIANCE. IF THIS PROCEDURE IS OMITTED THE APPLIANCE CAN ONLY BE LIT USING THE TOUCH PAD. SEE SECTION 3.
ENSURE THAT THE APPLIANCE IS CORRECTLY ADJUSTED FOR THE GAS TYPE AND CATEGORY APPLICABLE IN THE COUNTRY OF USE. REFER TO DATA BADGE AND TECHNICAL SPECIFICATIONS ON PAGE 8.
FOR DETAILS OF CHANGING BETWEEN GAS TYPES REFER TO SECTION 13 OF THE SERVICING INSTRUCTIONS.
1.SAFETY PRECAUTIONS
1.1This appliance must be installed in accordance with the rules in force, and used only in a sufficiently ventilated space. Please read these instructions before installation and use of this appliance.
1.2These instructions must be left intact with the user.
1.3Do not attempt to burn rubbish on this appliance.
1.4In your own interest, and those of safety, this appliance must be installed by competent persons in accordance with local and national codes of practice. Failure to install the appliance correctly could lead to prosecution.
1.5Keep all plastic bags away from young children.
2.INSTALLATION OF THE APPLIANCE
2.1Remove the appliance from the box and remove the two screws, one from either side near the top of the black surround. This will release the
2.2Decide on the position of the Linea and Decorative front and mark the intended position of the outer bottom edge of the frame. Refer to diagram 4 and 5 in the site requirements for overall dimensions of the decorative frames.
2.3Having marked the position of the outer bottom edge, position the template supplied ensuring that the line on the wall aligns with the appropriate decorative frame bottom edge on the template. See diagram 1.
1
2.4Having ensured that the template is level, mark the centre of the flue hole and the position of four fixing holes for the
Note: If a Vetro or Plano decorative front has been purchased, it will also be necessary to mark the positions of the four fixing holes for the front.
2
AR1347
TAKE CARE WHEN MARKING OUT THE FLUE AS IT IS VERY DIFFICULT TO MOVE AFTER INSTALLATION.
2.5A 152mm (6") diameter hole is required to install the flue. This can be achieved by either:
a)Core drill
b)Hammer and chisel
c)Drill small holes around the circumference, knock out the centre and make good at both ends.
2.6When the hole for the flue has been completed, insert the four brown rawplugs supplied and attach the fixing bracket using only the top two screws. See diagram 2a.
2a
AR1418
AR1332
12