Operation / Maintenance

PILOT BURNER

OPERATING INSTRUCTIONS

Purge all gas lines with the glass door open. Assure that a continuous gas flow is at the burner before clos- ing the door. Allow several minutes (5-15) for the flame to stabilize after ignition.

Do not operate the main burner of the in- sert with the door removed.

When lit for the first time, the fireplace will emit a slight odour for a few hours. This is a normal temporary condi- tion caused by the "burn-in" of paints and lubricants used in the manufacturing process and will not occur again. Simply open a window to sufficiently ventilate the room. After extended periods of non-operation such as following a vacation or a warm weather season, the fireplace may emit a slight odour for a few hours. This is caused by dust particles in the heat exchanger burning off. Open a window to sufficiently ventilate the room.

PURGE THE GAS LINE WITH THE GLASS DOOR OPEN.

FOR YOUR SAFETY READ BEFORE LIGHTING:

A. This fireplace is equipped with a pilot which must be lit by hand. While following these instructions exactly.

B. Before operating smell all around the fireplace area for gas and next to the floor because some gas is heavier than air and will settle on the floor.

C. Use only your hand to turn the gas control knob. Never use tools. If the knob will not turn by hand, do not try to repair it. Call a qualified service technician. Force or at- tempted repair may result in a fire or explosion.

D. Do not use this fireplace if any part has been under water. Immediately call a qualified service technician to inspect the fireplace and replace any part of the control system and any gas control which has been under water.

WHAT TO DO IF YOU SMELL GAS:

•Turn off all gas to the fireplace.

•Open windows.

•Do not try to light any appliance.

•Do not touch any electric switch; do not use any phone in your building.

•Immediately call your gas supplier from a neighbour's phone. Follow the gas supplier's instructions.

•If you cannot reach your gas supplier, call the fire depart-

ment.

THERMOPIL

THERMO-

COUPLE

FLAME ADJUSTMENT ON/OFF KNOB

KNOB

LIGHTING INSTRUCTIONS

When lighting and re-lighting, the gas knob cannot be turned from pilot to off unless the knob is depressed slightly.

1.Stop! Read the above safety information on this label.

2.Turn off all electric power to the fireplace.

3.Turn the gas knob clockwise to off.

4.Wait five (5) minutes to clear out any gas. If you smell gas including near the floor. Stop! Follow "B" in the above safety information on this label. If you don't smell gas go the next step.

5.If fireplace is equipped with flame adjustment valve turn clockwise to off.

6.Find pilot located in front of back log.

7. Turn gas knob counter-clockwise to pilot.

8.Depress slightly and hold gas knob while lighting the pilot with the push button ignitor. Keep knob depressed for one minute, then release. If pilot does not continue to burn, re- peat steps 3 through 7.

9.With pilot lit, depress and turn gas knob counter-clock- wise to on.

10.If equipped with flame adjustment valve, push and turn knob to high.

11.If equipped with remote on-off switch/thermostat, main burner may not come on when you turn valve to on. Remote switch must be in the on position to ignite burner.

12.Turn on all electric power to the fireplace.

TO TURN OFF GAS

1.Turn off all electrical power to the unit if service is to be performed.

2.Push in gas control knob slightly and turn clockwise to off. Do not force.

REAR BURNER CONROL

The purpose of the rear burner is to increase heat output or BTUs of the unit and will only operate when the main burner is functioning. To turn the rear burner on, simply depress the burner control knob (located in the valve compartment at the left hand side below the piezo igni- tor) and rotate the knob counter- clockwise to 'high'.

In order to achieve maximum turn down rate, the rear burner

must be turned off.

rear burner control knob

MAINTENANCE

TURN OFF THE GAS AND UNPLUG ELECTRICAL POWER

BEFORE SERVICING THE FIREPLACE INSERT!

CAUTION: Label all wires prior to disconnection when serv- icing controls. Wiring errors can cause improper and dan- gerous operation. Verify proper operation after servicing. This insert and its venting system should be inspected before use and at least annually by a qualified service per- son. The fireplace area must be kept clear and free of com- bustible materials, gasoline or other flammable vapours and liquids. The flow of combustion and ventilation air must not be obstructed.

1. In order to properly clean the burner and pilot assembly, remove the logs exposing both assemblies.

W415-0314 / C / 01.15.04

GDI-44N, GDI-44P specifications

Napoleon Grills has long been a trusted name in outdoor cooking, and their GDI-44P and GDI-44N models exemplify the brand's commitment to quality, performance, and innovation. These gas grills cater to both novice cooks and seasoned grill masters, making outdoor cooking accessible and enjoyable for everyone.

One of the standout features of the GDI-44P and GDI-44N is their impressive cooking surface. With a total cooking area of 825 square inches, these grills can accommodate a variety of dishes simultaneously, making them perfect for large gatherings and family barbecues. The primary cooking area is 644 square inches, providing ample space for grilling burgers, steaks, and veggies, while the secondary cooking area allows for indirect cooking or warming previously grilled items.

Equipped with Napoleon's innovative i-GLOW backlit control knobs, the GDI-44P and GDI-44N ensure visibility during nighttime grilling sessions. This feature not only enhances safety but also adds a stylish touch to the grill’s overall design. Additionally, the LED lights illuminate the cooking surface, allowing for precision cooking even after the sun goes down.

Both models utilize a powerful 44,000 BTU stainless steel burner system that delivers even heat distribution across the grill. The patented wave-shaped grill grates provide exceptional heat retention and sear marks, ensuring that food is cooked to perfection every time. The grills also include a rear infrared burner, ideal for rotisserie cooking, which complements the main grilling area by allowing cooks to prepare a whole chicken, roast, or other large cuts of meat with ease.

Durability is key in the construction of the GDI-44P and GDI-44N. Both grills feature a heavy-duty stainless steel body, which is resistant to corrosion and designed to withstand the elements year-round. The spacious side shelves provide additional prep space and come with integrated tool hooks for convenient access to grilling tools.

In terms of user-friendly technology, both grills feature an easy-to-use ignition system for reliable starts every time. The built-in temperature gauge allows for easy monitoring of cooking temperatures, ensuring perfectly grilled dishes.

In conclusion, the Napoleon Grills GDI-44P and GDI-44N are exemplary models that combine functionality, durability, and style. With their generous cooking space, advanced features, and reliable performance, they represent an excellent investment for anyone looking to enhance their outdoor cooking experience. Whether grilling for a large crowd or a family dinner, these grills deliver exceptional results, making them a worthy addition to any outdoor kitchen.