Hunter Fan 53177, 53173, 53175, 53172, 53171, 53176 operation manual Hand Tighten

Page 8

Downrod (continued)

www.HunterFan.com

1.888.830.1326

					E





					K	E
					K	P
							!

Remove the pre-installed

setscrew so that the downrod

can be inserted.

Hand tighten the downrod (at least 4-5 full turns) until it stops.

8”

The wires can be cut, but leave at least 8” extending from the top of the downrod.

Tighten the setscrew with pliers. DO NOT

HAND TIGHTEN.

3/8”

If the setscrew is not tightened securely, the fan may fall.

8

M0094-01 • 02/19/14 • © Hunter Fan Company

Image 8

Contents Table of Contents ? ?What to Expect with Your Installation Tools Needed Mounting Options For angled ceilings, point Opening toward peak Ceiling BracketMake sure all four 4 bumpers Are still attached Preparation Downrod Hand Tighten Put the wires and downrod through FanWiring Canopy HolesBlades Switch Housing Feed the wire plug through the centerPull chain through the hole in the light kit Switch housing with the upper switchLight Kit Chain Install a bulb into eachKeeper Maintenance & Cleaning Customer serviceTroubleshooting Fan doesn’t work