Installing your Microwave Oven

Recommendations

DO NOT install the microwave oven in hot or damp surroundings.

Example: Next to a traditional oven or radiator.

The power supply specifications of the oven must be respected and any extension cable used must be of the same standard as the power cable supplied with the oven.

Wipe the interior and the door seal with a damp cloth before using your microwave oven for the first time.

This microwave oven can be placed almost anywhere (kitchen work surface or shelf, movable trolley, table).

☛For your personal safety, this appliance must be:

◆Properly earthed (3-pin plug)

◆Plugged into a standard 230 Volt, 50 Hz, AC earthed socket

1Install the oven on a flat, level, stable surface. Make sure there is adequate ventilation for your oven by leaving at least 10cm(four inches) of space behind and on the sides of the oven and 20cm(eight inches) above. (For stacking see page 17.)

2Never block the air vents as the oven may overheat and automatically switch itself off. It will remain inoperable until it has cooled sufficiently.

3Remove all packing materials inside the oven.

4Plug the cable into a 3-pin, earthed socket. If the power cable of this appliance is damaged, it must be replaced by a special cable as supplied from service center.

☛Be sure to remove the protective film from outer case. The protective film is on the outer case to prevent scratches.

When installing or before using, be sure to remove it.

Outdoor use

This microwave oven is not designed for outdoor use. You should use it indoors only.

During Air cooling

Do not turn power off while the fan is automatically air-cooling for 1min.