Settings
Support
Software Upgrade
For more information about this function see page 23.
Contact Samsung
Provides contact information for assistance with your product.
Terms of Service Agreement
View the general disclaimer regarding third party contents and services.
Reset
Reverts all settings to their defaults except for the network. Requires that you enter your security PIN. The default security PIN is 0000.
Network Setup
When you connect this product to a network, you can use network based applications and functions such as
Configuring Your Network Connection
To begin configuring your network connection, follow these steps:
1.In the Home screen, select Settings, and then press the E button.
2.Select Network, and then press the E button.
3.Select Network Settings, and then press the E button.
4.Go to the instructions for Wired networks starting below or the instructions for Wireless networks. (See page 21)
Wired Network
Wired – Automatic
After following Steps 1 to 3 above:
1.In the Network Settings screen, change Network Type to Wired. Then, select Connect and press the E button. The product detects the wired connection, verifies the network connection, and then connects to the network.
2.When it is done, highlight OK, and then press E button.
Wired - Manual
If you have a static IP address or the automatic procedure does not work, you'll need to set the Network Settings values manually.
After following Steps 1 to 3 above:
1.In the Network Settings screen, change Network Type to Wired. Then, select Connect and press the E button.
The product searches for a network, and then displays the connection failed message.
✎If it is possible to connect the home cinema to your network wirelessly, select Change Network at this point, change the Network Type to Wireless, and then go to the instructions for wireless networks. (See page 21)
Network Settings
Wired network connection failed.
MAC Address | XX:XX:XX:XX:XX:XX | |||
IP Address | 0. | 0. | 0. | 0 |
Subnet Mask | 0. | 0. | 0. | 0 |
Gateway | 0. | 0. | 0. | 0 |
DNS Server | 0. | 0. | 0. | 0 |
IP auto setting failed. Try the following to set up the IP automatically, or set up the IP manually by selecting IP Settings.
-Ensure that the DHCP server is enabled on the wireless network, then unplug and plug the wireless network in again.
-Contact your internet service provider for more info.
Change Network | IP Settings | Retry | Close |
| a Previous | d Skip | < Move " Select |
2.Use the ◄► buttons to select IP Settings, and then press the E button. The IP Settings screen appears.
3.Select the IP setting field, and then set it to Enter manually.
4.Select a parameter to enter (IP Address, for example), and then press E. Use the number keypad on your remote control to enter the numbers for the parameter. You can also enter numbers using the ▲▼ buttons. Use the ◄► buttons on the remote control to move from entry field to entry field within a parameter. When done with one parameter, press the E button.
5.Press the ▲ or ▼ button to move to another parameter, and then enter the numbers for that parameter following the instructions in Step 4.