Samsung Official Manual for HT-H5550, H5500, and HT-H5550W Connections

Connections

✎The maximum transmission distance from the product to the wireless receiver module is about 10m, but may vary depending on your operating environment. If a steel-concrete wall or metallic wall is between the product and the wireless receiver module, the system may not operate at all, because the radio waves cannot penetrate metal.

✎If the product doesn't make a wireless connection, you need to run an ID Set between the product and wireless receiver module. With the product turned off, press "0""1""3""5" on the remote control. Turn on the wireless receiver module. Then, press and hold the "ID SET" button on the back of the wireless receiver module for 5 seconds, and then turn the product on.

CAUTION

￿If you want to install the speakers on the wall, fasten screws or nails (not provided) firmly to the wall wherever you want to hang a speaker, and then, using the hole in the rear of each speaker, carefully hang each speaker on a screw or nail.

￿Do not let children play with or near the speakers. They could get hurt if a speaker falls.

￿When connecting the speaker wires to the speakers, make sure that the polarity (+/–) is correct.

￿Keep the subwoofer speaker out of reach of children to prevent children from inserting their hands or alien substances into the duct (hole) of the subwoofer speaker.

￿Do not hang the subwoofer on the wall using the duct (hole).

￿The wireless receiving antenna is built into the wireless receiver module. Keep it away from water and moisture.

￿For optimal listening performance, make sure that the area around the wireless receiver module location is clear of any obstructions.

￿In 2-CH mode, you will hear no sound from the wireless surround speakers.

Attaching the Toroidal Ferrite Core to the Power Cord of the Wireless

Receiver Module (SWA-6000)

* HT-H5500W/HT-H5550W only

If you attach a Toroidal ferrite core to the power cord of the wireless receiver module, it will help prevent RF interference from radio signals.

1. Pull the fixing tab of the Toroidal ferrite core to open it.

2.Make two loops in the wireless receiver module power cord.

3.Attach the Toroidal ferrite core to the wireless receiver module power cord as shown in the figure on the right, and then close it by

pressiing it until it clicks.

• Attach the ferrite core as close to the Wireless Receiver Module as possible.

12 - English