Samsung SCC-C6407P manual Installing the Camera

Installing the Camera

1.[Figure 1] Install the structure on the ceiling.

(Refer to Installation reference for the Length of the structure)

* Built in by the builder of the structure

5. [Figure 5] Match the	6. Pull the safety wire from the case
BRKT-ANCHOR and CAMERA	body, and assembly it to the
ADAPTER and use 4screws	camera holder.
(PH M4 x 8) to assemble them.
[Figure 5]	[Figure 6]

E

[Figure 1]

2.Make a hole in the ceiling where the camera will be installed. (The hole should be about ø185)

3.[Figure 2] Assemble the

BRKT-ANCHOR on the ceiling and screw the 4 bolts in.

Length of ceiling Hole

7.[Figure 7] Match the 3 holes on the back of the CAMERA and the

CONNECTOR and turn it left about 15 degrees.

[Figure 7]

[Figure 2]

4.[Figure 3,4] Connect the various cables to the CAMERA ADAPTER. (See page 2-4)

[Figure 3]

[Figure 4]

(Check the sound of LOCKING and that the LEVER-LOCKING is in place)

*Use the screws (BH M3 x L8) to connect the CAMERA and the ADAPTER so they don't move.

8.[Figure 8] Assemble the COVER-BODY onto the DOME.

[Figure 8]

2-8 2-9