Samsung WW60K42109W/EO Installation requirements, Electrical supply and grounding, Water supply

Page 17

Installation requirements

Electrical supply and grounding

AC 220-240 V / 50 Hz fuse or circuit breaker is required.

Use an individual branch circuit specific to the washing machine.

To ensure proper grounding, the washing machine comes with a power cord featuring a three-prong grounding plug for use in a properly installed and grounded outlet.

Check with a qualified electrician or service person if you are not sure about the grounding.

Do not modify the provided plug. If it does not fit the outlet, call a qualified electrician to install a proper outlet.

WARNING

Do NOT use an extension cord.

Use only the power cord that comes with the washing machine.

Do NOT connect the ground wire to plastic plumbing, gas lines, or hot water pipes.

Improperly connected grounding conductors may cause electric shock.

Water supply

A proper water pressure for this washing machine is between 50 kPa and 800 kPa. Water pressure less than 50 kPa may cause the water valve not to close completely. Or, it may take longer to fill the drum, causing the washing machine to turn off. Water taps must be within 120 cm from the rear of the washing machine so that the provided inlet hoses reach the washing machine.

To reduce the risk of leaks:

Make sure water taps are easily accessible.

Turn off the taps when the washing machine is not in use.

Check for any leaks at the water inlet hose fittings on a regular basis.

CAUTION

Before using the washing machine for the first time, check all connections at the water valve and taps for any leaks.

Drain

Samsung recommends a standpipe in height of 60-90 cm. The drain hose must be connected through the hose clip to the standpipe, and the standpipe must fully cover the drain hose.

Installation

English  17 

Untitled-11 17

3/23/2017 8:41:08 PM

Image 17
Contents WW70K4*****/WW60K4 Washing MachineContents Specifications TroubleshootingSafety information Important safety precautions Critical installation warnings English 7  Critical usage warnings Installation cautionsEnglish 9  Usage cautions English 11  Safety information Critical cleaning warnings Instructions about the Weee What’s included InstallationSpanner Bolt caps Hose guide Electrical supply and grounding Installation requirementsWater supply DrainFlooring Water temperatureAlcove installation Remove the shipping bolts Step-by-step installationSelect a location Connect the water hose Adjust the levelling feetEnglish 21  Untitled-11 23/2017 84110 PM English 23  Position the drain hose Power onBefore you start Initial settingsLaundry guidelines Run Calibration recommendedUse a laundry net Empty pocketsPrewash if necessary Determine the load capacityApply a proper detergent type Detergent drawer guidelines To apply washing agents to the detergent drawer Before you start Control panel OperationsPress to activate/deactivate the Bubble Soak function. This To change the cycle during operation Simple steps to startStandard cycles Cycle overviewWool Options Delay End AddWash Special featuresEnglish 39  Sound On/Off SettingsChild Lock Eco drum clean MaintenanceSmart Check Emergency drain Add Door CleaningSurface of the washing machine Mesh filter Pump filter Detergent drawer Care against an extended time of disuse Recovery from freezingCheckpoints TroubleshootingTroubleshooting Change as the automatic temperature control feature checks Troubleshooting Information codes Troubleshooting AC6 Fabric care chart SpecificationsProtecting the environment Specification sheet English 59  Specifications Information of main washing cycles Memo Memo Questions or COMMENTS? Country Call Or Visit US Online AT