Samsung WW60K42138W/EO, WW60K42109W/EO manual Position the drain hose, Power on

Page 24

Installation

Installation

STEP  5  Position the drain hose

The drain hose can be positioned in three ways:

 

Over the edge of a wash basin

 

The drain hose must be placed at a height

 

of between 60 cm and 90 cm (*) from the

 

floor. To keep the spout of the drain hose

A

bent, use the supplied plastic hose guide

 

(A). Secure the guide to the wall using a

 

hook to ensure stable drainage.

 

ln a sink drain pipe

 

The drain pipe must be above the sink

 

siphon so that the end of the hose is at

 

least 60 cm above the floor.

 

ln a drain pipe

 

The drain pipe should be between 60 cm

 

and 90 cm high (*). It is advisable to use

 

a 65 cm high vertical pipe. Make sure the

 

drain hose is connected to the stand pipe

 

at a slant.

 

Drain standpipe requirements:

 

• Minimum diameter of 5 cm

 

• Minimum carry-away capacity of

 

60 litres per minute

STEP  6  Power on

Plug the power cord into a wall socket featuring an AC 220-240 V / 50 Hz approved electrical outlet protected by a fuse or circuit breaker. Then, press Power to turn on the washing machine.

24  English

Untitled-11 24

3/23/2017 8:41:10 PM

Image 24
Contents Washing Machine WW70K4*****/WW60K4Contents Troubleshooting SpecificationsSafety information Important safety precautions Critical installation warnings English 7  Installation cautions Critical usage warningsEnglish 9  Usage cautions English 11  Safety information Critical cleaning warnings Instructions about the Weee Installation What’s includedSpanner Bolt caps Hose guide Installation requirements Electrical supply and groundingWater supply DrainWater temperature Alcove installationFlooring Step-by-step installation Select a locationRemove the shipping bolts Adjust the levelling feet Connect the water hoseEnglish 21  Untitled-11 23/2017 84110 PM English 23  Power on Position the drain hoseInitial settings Before you startLaundry guidelines Run Calibration recommendedEmpty pockets Use a laundry netPrewash if necessary Determine the load capacityApply a proper detergent type Detergent drawer guidelines To apply washing agents to the detergent drawer Before you start Operations Control panelPress to activate/deactivate the Bubble Soak function. This Simple steps to start To change the cycle during operationCycle overview Standard cyclesWool Options Delay End Special features AddWashEnglish 39  Settings Child LockSound On/Off Maintenance Eco drum cleanSmart Check Emergency drain Cleaning Surface of the washing machineAdd Door Mesh filter Pump filter Detergent drawer Recovery from freezing Care against an extended time of disuseTroubleshooting CheckpointsTroubleshooting Change as the automatic temperature control feature checks Troubleshooting Information codes Troubleshooting AC6 Specifications Fabric care chartProtecting the environment Specification sheet English 59  Specifications Information of main washing cycles Memo Memo Questions or COMMENTS? Country Call Or Visit US Online AT