Samsung BT62CDBSTL/XET manual Catalytic enamel surface, Cleaning by hand

Page 39

Cleaning and Care (continued)

Catalytic enamel surface

EN

 

The removable cover casing is coated with a dark gray catalytic enamel that can become coated with oil and fat distributed by circulating air during convection heating. These deposits will burn off at oven temperatures of 200 °C and higher, for example, when baking or roasting. Higher temperatures will result in faster burning.

The oven and accessories should be cleaned after each use. Otherwise further baking and roasting will cause the deposits to bake on even harder and cleaning may become difficult and

in extreme cases impossible.

Cleaning by hand

Make sure the oven is cool before cleaning.

The catalytic enameled cover casing should be cleaned using a solution of hot water and washing-up liquid applied with a soft nylon brush.

Do not use abrasive cleaning agents, hard brushes, scouring pads or cloths, steel wool, knives or other abrasive materials. Do not use oven spray on catalytic enamel as the chemicals used in oven sprays will damage catalytic enamel and render it ineffective.

If using oven sprays on the interior oven surfaces, the catalytic cover casing must first be removed from the oven.

Cleaning with high temperatures

Before cleaning the catalytic cover casing with high temperatures, make sure that all interior oven surfaces have been cleaned as described above. Otherwise, the high temperatures can bake deposits onto the interior oven surfaces and make them impossible to remove.

If, after manual cleaning, the oven is still heavily soiled, heating it to a high temperature will help remove soiling caused by oil and grease splashes.

Note that deposits of spices, syrups and similar substances are not removed by this process. These should be removed by hand with a mild solution of hot water and washing-up liquid ap- plied with a soft brush.

Remove all accessories from the oven.

Set the oven to conventional function.

Set the heat to 250 °C.

Run the oven for approximately 1 hour. The length of time will depend on the degree of soiling.

It is a good idea to set the finish time for the process using the end time setting, in case you forget to switch the oven off at the end.

Any remaining soil will gradually disappear with each subsequent use of the oven at high temperatures.

37

Image 39
Contents Built-In Oven Page Contents ImportantNote Using This ManualSafety Instructions Electrical safetyDisposal Instructions Safety during operationInstalling the Oven Safety instructions for the installerInstalling into a low cabinet Connecting to the mains power supply Installing into a high cabinet Oven Parts and FeaturesOven controls Special featuresFollowing accessories are provided with your oven AccessoriesUsing the accessories Safety shutoffCooling fan Before You Begin Setting the clockTo clean the oven Initial cleaningConventional Oven functionsTop Heat + Convection Food Item Large Grill PUT in Cold Oven Small GrillBrush EGG YOLK, PUT Cold Oven Bottom Heat + ConvectionSuggest 2 Cooking at different cooking modes Twin ModeTest dishes BakingGrilling Turn the Divider Select Knob to Setting the divider modeDivider Marking Oven Function Insert Usage Information Mode Oven UseLower mode Upper modeTwin mode Single mode Setting the oven temperature Press the Temperature Button twiceSingle, upper and lower modes Press the End Time Button Switching the oven offEnd time Select Knob to the Off positionOven Use Press the Cook Time Button Cook timeOven Use Delayed start Case 1 Cook time is entered firstTurn the Time/Temp Control Knob to set the end time Turn the Time / Temp Control Knob to set the cook time Case 2 End time is entered firstOven lamp on/off Kitchen timerSwitching the beeper off Child safety functionSteam cleaning Cleaning and CareTips After deactivating the Steam CleaningTurn the Time / Temp Control Knob to convection Rapid dryingCleaning by hand Cleaning with high temperaturesCatalytic enamel surface Removing the door Cleaning the oven doorAttaching the door Detach the inner sheet, glass #1, from the door Disassembling the doorSide Runners Assembling the doorDetaching the Side Runners Remove the screw at the front by turning it Attaching the Side Runners  Danger of electric shock Replacing the rear oven lamp and cleaning the glass capReplacing the oven side lamp and cleaning the glass cap Changing the lampFAQs and Troubleshooting Warranty & ServiceCentre Error and Safety codesGeneral Functions Solution Call local Samsung serviceTechnical data WeightDimensions W x H x D Code No. DG68-00126C
Related manuals
Manual 50 pages 56.23 Kb