Drain facility
The recommended height of the standpipe is 39 in/ 99 cm. The drain hose must be routed through the drain hose clip to the standpipe. The standpipe must be large enough to accept the outside diameter of the drain hose. The drain hose is attached to the washer at the factory.
Flooring
For best performance, you must install your washer on a solidly constructed floor. Wood floors may need to be reinforced to minimize vibration and/or unbalanced load situations. Carpeting and soft tile surfaces are contributing factors to vibration which can cause your washer to move slightly during the spin cycle.
Never install your washer on a platform or weakly supported structure.
Location considerations
Do not install your washer in areas where water may freeze, since your washer will always retain some water in its water valve, pump, and hose areas. Frozen water can damage the belts, the pump, hoses, and other components.
Alcove or closet installation
MINIMUM CLEARANCES FOR CLOSET AND ALCOVE INSTALLATIONS:
Sides – 1 in / 25 mm | Closet Front – 2 in / 51 mm |
Rear – 6 in / 152 mm | TOP - 21 in / 533 mm |
If the washer and dryer are installed together, the closet front must have at least a 72 in² (465 cm²) unobstructed air opening. Your washer alone does not require a specific air opening.
A |
| B |
|
21in.
(53.3 cm)
01 installing your washer
1 in. |
|
|
|
| 27in. |
|
|
|
| 1 in. | 2 in. |
|
|
|
| 27.1in. |
|
|
|
| 6 in |
|
|
|
|
|
|
|
| ||||||||||||||
(2.5 cm) |
|
|
| (68.6 cm) |
|
|
| (2.5 cm) | (5 cm) |
|
|
| (69 cm) |
|
| (15.2 cm) |
A. Recessed area
B. Side view - closet or confined area
installing your washer _13