Samsung WA186DSHASU/YL manual Information Codes

troubleshooting

INFORMATION CODES

The Washer may display information codes to help you understand what is occurring with your Washer better.

CODE SYMBOL	MEANING	SOLUTION
	Unbalanced load prevented your	Redistribute the load, press the Start/Pause
	Washer from spinning.	Button.
	Door is open when Washer is	Close the door tightly and restart the cycle.
	running.	If the code reappears, call for service.
	Your Washer failed to lock the	Close the door tightly and restart the cycle.
	door.	If the code reappears, call for service.
	Water temperature control	Call for service.
	problem.
	(Heater Control problem)
	Your Washer has tried to fill but	Call for service.
	has not reached the proper water
	level.
	The door will not unlock.	Make sure the door is firmly closed.
		Push the Power button to turn off your Washer,
		then turn it on again. If the code reappears, call
		for service.
	Motor not running properly.	Restart the cycle pressing the Start/Pause
		Button. If the code reappears, call for service.
	Your washer is not draining.	Do the following:
	It can also mean that the unit	1) Turn off the unit and turn it on again.
	senses a small clog while draining.	2) Select only the Spin Cycle.
		3) Press the Start/Pause to drain the water.
		If it still does not drain, call for service.
	Your Washer has tried to fill but	Make sure the water faucets are open all the
	was unsuccessful.	way. Check for kinked hoses.
		Check the inlet screens on the fill hoses.
		If you use a Flood Safety Device, then please
		remove the device and connect the water hoses
		directly to the unit.
	Check if the hot water supply	You must connect the hot water supply hose
	hose is connected.	because hot water is supplied by the Auto
		Temperature Control (A.T.C.) function.
	The hot/cold water hose	Please connect the hot/cold water hose
	connection is not correct.	connection correctly.
	A fault is detected in the water	Call for service
	level sensor.
	Jammed Key.	Call for service
	Temperature sensor problem.	Restart the cycle.
		If the code reappears, call for service.

30_ troubleshooting

WA186DSHASU-02703E_EN_130131.indd Sec10:30 2013-01-31 ￿￿ 5:57:40