IMPORTANT NOTE TO INSTALLER
Please read the following instructions carefully before installing your Washer.
These instructions should be retained for future reference.
We recommend you hire a professional to install this washer.
STEP 1
Selecting a Location
Before you install your washer, make sure the location:
•Has a hard, level surface without carpeting or flooring that may obstruct ventilation.
•Has no dust, oil and detergent etc.
•Is away from direct sunlight
•Has adequate ventilation
•Will not freeze (temperatures are never below 32 °F or 0 °C)
•Is away from heat sources such as oil or gas
•Provides enough slack for the power cord.
•Doesn’t have any carpeting that will obstruct ventilation openings.
STEP 2
Installing your Washer
1.If you use a stand pipe, make sure the connection between the drain hose and the standpipe is NOT airtight.
The standpipe must be at least 39 in or 99 cm high.
01 installing your washer
You must always exercise caution to avoid collapsing or damaging the drain hose. For best results, the drain hose should not be restricted in any way
–by elbows, couplings, or excessive length. For situations where the drain hose cannot be conveniently elevated to at least 39 in or 99 cm, the drain hose must be supported.
Do not insert the drain hose too far into the stand pipe: 6 - 8 inches, and no more.
96”
Max
Hose 
retainer
39”
Tie strap
installing your washer _15