STEP 2
Connecting the water and the drain
Connecting the water supply hose
Before installing the water supply hoses, make sure there are CAUTION rubber gaskets inside the fittings at both ends of each new
water hose. Installing the water supply hoses without rubber gaskets can cause water leakage.
When you initially install the washer, be sure to use new hoses.
CAUTION Failing to do so may result in a water leakage or overflow | and |
|
|
|
| ||
may damage your property. |
|
|
|
|
|
| |
Do not connect multiple water supply hoses together to | Coupling | ||
CAUTION increase the length of the supply hose. Hoses connected this way can leak and the leakage can cause electrical shock. If a hose is too short, replace the hose with a longer, high pressure hose.
1.Connect the ends of the water supply hoses to the HOT and COLD faucets.
2.Tighten the fittings by hand until they are snug, and then tighten them an additional
When you fasten the fittings, do not fasten them too tightly or apply CAUTION tape or sealant to the faucets or water supply intakes. This can
damage the fittings.
After you have connected the water supply hoses to the faucets, ensure that they are connected correctly by pulling the water supply hoses downwards
3.Place the unconnected ends of the hoses into a bucket and open the faucets connected to the two water supply hoses for 10 or 15 seconds to remove any foreign substances from the hoses. Close the faucets before continuing.
4.Connect the ends of the water supply hoses to the water supply intake connections at the back of the washer.
The water supply hose connected to the HOT faucet must be CAUTION connected to the hot water supply intake and the water hose
connected to the COLD faucet must be connected to the COLD water supply intake.
5.Tighten the fittings by hand until they are snug, and then tighten them an additional
To ensure the correct water usage, connect both the HOT and COLD water faucets. If either or both are not connected, an “4E” (no fill) error can occur.
If you do not want to use the HOT water supply hose, insert the water intake cap into the HOT water supply intake hole.
Confirm that the water supply hoses are not twisted or bent. If CAUTION the hoses are twisted or bent, the hoses can leak and cause
electric shock due to the water leakage.
6. Turn on the HOT and COLD water supplies and check all the water supply intake connections and the faucets for water leaks.
Rubber Washer
Cold Hot
01 installing your washer
English - 15
2015/7/28 10:38:50