Information codes
The Washer may display information codes to help you understand what is occurring with your Washer better.
CODE SYMBOL MEANING | SOLUTION |
|
|
The Water Level sensor is not | Call for service. |
working properly. |
|
When the washer displays the “1E” code, the washer do draining for 3 minutes. During this time, the Power button is inoperative.
Your Washer has tried to fill but | Make sure the water faucets are open all the | |
was unsuccessful. | way. Check for kinked hoses. | |
Check if the hot water supply | Check the inlet screens on the fill hoses. | |
hose is connected. | If you use a Flood Safety Device, then please | |
| ||
When the washer displays | remove the device and connect the water hoses | |
directly to the unit. | ||
the “4E” code, the washer do | ||
| ||
draining for 3 minutes. During | You must connect the hot water supply hose | |
this time, the Power button is | because hot water is supplied by the Auto | |
inoperative. | Temperature Control (A.T.C.) function. | |
|
| |
Your washer is not draining. It can | Do the following: | |
also mean that the unit senses a | 1) Turn off the unit and turn it on again. | |
small clog while draining. | ||
2) Select only the Spin Cycle. | ||
| ||
| 3) Press the Start/Pause to drain the water. | |
| If it still does not drain, call for service. | |
|
| |
Your Washer has tried to fill but | Call for service. | |
has not reached the proper water |
| |
level. |
| |
When the washer displays |
| |
the “LE” code, the washer do |
| |
draining for 3 minutes. During |
| |
this time, the Power button is |
| |
inoperative. |
| |
|
| |
Unbalanced load prevented your | Redistribute the load, press the Start/Pause | |
Washer from spinning. | button. | |
|
| |
Lid is open when washer is | Close the lid tightly and restart the cycle. If the | |
running. | code reappears, call for service. | |
|
| |
The lid switch is not working | Turn the power on again after 2~3 minutes | |
properly. | and restart from the beginning. If the problem | |
| continues, call for service. | |
|
| |
Jammed Key. | Call for service | |
|
| |
Motor not running properly. | Restart the cycle pressing the Start/Pause | |
| button. If the code reappears, call for service. |
05 troubleshooting
English - 33
2015/7/28 10:38:55