ADDING DETERGENT
1.Open the detergent drawer and then add the powder
detergent into the detergent compartment. 2. Add detergent evenly so that it doesn’t brim over the
edge of the drawer.
• Use a reasonable amount of detergent. If you use more detergent than the standard quantity or the water temperature is too low and the
detergent does not dissolve in the water completely
causing it to remain on the laundry and in the hose and tub, it may cause damage such as dirtying and discoloring the laundry.
•If you use a powder detergent and it remains on the laundry, it may cause a bad odor. Rinse the laundry suffi ciently in fresh water.
If you spread a powder detergent over the laundry directly, it may result in discoloration. CAUTION Make sure to insert it into the detergent compartment.
If the water pressure is low, the detergent may remain in the detergent compartment. Using the liquid detergent
•To use the liquid detergent, place the liquid detergent container into the detergent compartment and add the liquid detergent into the liquid detergent container.
•Do not add the powder detergent into the liquid detergent container. Remove the liquid detergent container before using the powder detergent.
ADDING FABRIC SOFTENER
1.When the proper amount (one time dose) of fabric softener is stored in the softener inlet, it is automatically added during the last rinse cycle.
2.Do not add detergent, bleach or starch into the softener inlet.
3.Using too much softener may produce unsatisfactory results.
4.Do not open the lid during the Spin cycle. If added too early, its effectiveness will decrease.
5.Do not leave the softener in the softener dispenser for a long time as it may congeal.
If the water pressure is low, the fabric softener may remain in the softener compartment. In this case, put the fabric softener into the tub directly.
WATER SUPPLY CONNECTOR FILTER
1.Pull out the fi lter and wash well.
2. Pull in the fi lter and connect the hose to the inlet water valve tightly.
3. Check if there is a leakage.
Note to tighten up the connector.
03 INSTALLATION & MAINTENANCE
installation & maintenance_21