Connecting to the mains power supply

Before connecting, check that the nominal voltage of the appliance, that is, the voltage stated on the rating plate, corresponds to the available supply voltage. The rating plate is located on the lower casing of the hob.

Shut off power to circuit before connecting wires to circuit.

WARNING

The heating element voltage is AC 230 V~. The appliance also works perfectly on networks with AC 220 V~ or AC 240 V~.

The hob is to be connected to the mains using a device that allows the appliance to be disconnected from the mains at all poles with a contact opening width of at least 3 mm, eg. automatic line protecting cut - out, earth leakage trips or fuse.

The cable connections must be made in accordance with regulations and WARNING the terminal screws tightened securely.

Once the hob is connected to the mains supply, check that all cooking zones are WARNING ready for use by briefly switching each on in turn at the maximum setting with suit-

able cookware.

When the hob is powered on for the first time, all displays light and the child safety lock is activated.

Pay attention (conformity) to phase and neutral allocation of house connection and WARNING appliance (connection schemes); otherwise, components can be damaged.

Warranty does not cover damage resulting from improper installation.

If the supply cord is damaged, it must be replaced by a special cord or assembly WARNING available from the manufacturer or its service agent.

• 1N ~

• 2N ~

220-240 V ~

Green/Yellow

380-415

V ~

Green/Yellow

Black

Blue

Black

Blue

Gray

Brown

Gray

Brown

L1 L2

1N ~

2N ~

•2 x 1N ~

220-240 V ~

Green/Yellow

Blue

Black

For correct supply connection, follow

WARNING the wiring diagram attached near the

Brown

Gray

terminals.

L1 N1

L2 N2

2 X 1N ~

installing the hob _13

hobe t ginstall

CTN464KC01_BOL_DG68-00454A-02_EN_121129.indd 13

2012-11-29 �� 5:17:02