Crimestopper Security Products CS-2011DP manual Wiring 9-PIN Connector, Brown + Siren Output

WIRING: 9-PIN Connector

Green: MODE A: (-) Start Activation Input
This wire allows an outside source or accessory to	Optional Turbo Timer Wiring
activate a Remote Start. A 1-second Ground pulse			Momentary
on this wire will trigger a remote start. This wire
			Switch
can be used with an RS-400 temperature module.
	GREEN
Green: MODE B (-) Optional Turbo Timer Input
This wire allows the system to keep a vehicle		(Not included)
running for 1-5 minutes [selectively] after removing
the key. This mode requires the use of a

momentary switch that is not included with the kit. Connect a 2-pole momentary switch with one side to chassis Ground and the other side to the Green input wire. If you own a turbo or turbo diesel vehicle, you can now allow the CoolStart system to keep your engine running for 1-5 minutes after exiting/locking your vehicle to cool-down without the need for an external “Turbo Timer”. See operator’s manual for more information. When using turbo timer and passive arming, you must turn program option #3 “OFF”.

Brown: (+) Siren Output

Connect brown wire to siren red wire. Connect black wire of siren to chassis ground (body metal).

Brown/White: (-) 500mA Horn Honk Output (Optional, may require a relay)

Connect to the Negative Horn Trigger wire usually located near the steering column. If the vehicle horn circuit requires +12V, a relay is required. RELAY WIRING: Connect the Brown/White wire to terminal 85, connect relay terminals 86 and 87 to +12V constant power. Connect terminal 30 of the relay to the +12V positive device/circuit to be activated.

Black/White: (-) 500mA Dome Light Illumination Output (Optional, Requires relay)

Negative Dome Light System: Connects to terminal 85 of a relay. Connect terminals 86 +12V Constant. Connect terminal 87 to Chassis Ground and Connect Terminal 30 to the Negative dome light activation circuit.

Positive Dome Light System: Connects to terminal 85 of a relay. Connect terminals 86 & 87 to +12V Constant. Connect terminal 30 to the Positive dome light activation circuit.

4