Crimestopper Security Products CS-2012DP-TW1 Orange Negative Starter Disable/Anti-Grind Output

WIRING: 9-PIN Connector Cont.

Blue/White: (-) Passenger Door Unlock Output (Optional, requires relay)

This wire activates when the unlock button on the remote is pressed a second time within 15 seconds upon disarming. This wire is used for the Optional Separate Driver’s/Passenger Unlock feature. Connects to unlock circuit for passenger door or doors. See DOOR LOCK WIRING for special configuration options.

Orange: (-) Negative Starter Disable/Anti-Grind Output

This wire should be connected to the Yellow wire of the pre-wired relay socket for the starter disable. Connect the blue wire of the relay socket to the Ignition switched wire on the vehicle. Cut the vehicle starter wire and connect each half to an Orange wire on the relay socket. This output also turns on with remote start to function as an “Anti Grind” wire to prevent the starter from grinding if you get in your car and turn the key too far after it was remote started. See starter disable diagram on next page.

STARTER DISABLE:

	IGN. SWITCHED	IGNITION SWITCHED
		"ON" & HOT THROUGH
		CRANKING
	STARTER WIRE
CONNECT TO		CUT
	YELLOW
ORANGE WIRE
OF ALARM		STARTER
PRE-WIRED
STARTER DISABLE	BLUE
RELAY & SOCKET	ORANGE	MAKE CERTAIN TO
	ORANGE
		CONNECT BROWN
START OUTPUT		WIRE TO STARTER
		MOTOR SIDE!!!
FROM ALARM	BROWN
6-PIN HARNESS

6