E N G L I S H
Assembly
Operating Instructions
To assist you in identifying components of your vacuum, the parts have been numbered as follows:
1Handle section, upper
2Tube, lower
3Power head
4Outer bag
5Paper filter dust bag
6 Power cord | 5 |
7Retaining spring
8Bag tension bar
9Zip fastener
10On/off switch
11Cord hook
12Plastic loop/cable clamp
13Connector assembly
14Fan housing
15Cord assembly
| 10 |
9 | 11 |
1 | |
| 12 |
13
4
|
| 2 | 6 |
|
|
| |
8 | 7 | 14 | 15 |
| |||
|
|
| |
3 |
|
|
|
To Operate
Make sure disposable paper filter dust bag is in place. DO NOT operate the cleaner without a paper filter dust bag.
Plug the power cord into an electrical outlet and press the On(l) - OFF(O) switch on handle assembly when ready to operate.
General Information
The performance of your new cleaner greatly depends upon care and maintenance. The instructions in this manual will guide you in performing basic care and maintenance. To obtain the most satisfying years of service read the instructions and keep them handy for future reference.
Operating Recommendations
This new ORECK XL
The following are a few simple suggestions regarding its operation:
1 | Before assembling appliance, |
| remove two screws from the |
| connector assembly. Remove |
| cardboard insert by pulling |
| upward. |
1. | When inserting a new disposable paper filter dust bag— |
| FIRST PUFF OUT and OPEN THE BAG. |
2. | When the disposable filter dust bag is full, REPLACE IT. |
3. | If at any time the machine does not pick up properly or |
| makes an unusual noise, STOP OPERATION and service. |
4. | Although your upright will pick up pins, paper clips, and |
| other small objects, it is recommended that these be |
| removed from the floor before you vacuum. Failure to do |
| so may result in permanent damage to the motor suction |
| fan and its housing. |
5. | WARNING: Do not use your vacuum cleaner on damp |
| or wet surfaces. This will cause damage to the vacuum |
2 | Upper |
| Handle |
| Connector |
| Assembly |
3 |
|
With ON/OFF switch facing the front of the unit, slide upper handle section over matching section of the connector assembly. Insert short screw into top hole and long screw into the bottom hole then tighten firmly until handle is no longer loose.
Attach cord to cord clip by pressing cord above and below clip ensuring the cord is fully rested in clip.
| cleaner and is dangerous to the user. Damage caused by |
| use on wet or damp surfaces is not covered under |
| warranty. |
6. | REPLACE THE BELT EVERY 6 MONTHS. |
7. | Change the disposable filter dust bag at least once a |
| |
| bag can cause odor, attract moisture, act as a breeding |
| area and can affect the efficie cy f the cleaner. |
8. | DO NOT run the vacuum cleaner over cord. The |
| revolving brush could damage the cord. |
Disposable Paper Filter Dust Bags
Disposable paper filter dust bags play a very important role in the efficiency of your ORECK vacuum cleaner. The purpose of the paper bag is to trap dirt, but at the same time it must be porous enough to allow air to pass through. If the paper bag becomes clogged, no air can pass through the cleaner and cleaning cannot take place, regardless of the cleaner’s power. Increase the CLEANING POWER of your cleaner by changing the bag often.
To keep your cleaner operating at maximum efficiency, change the dust bag frequently. DO NOT FILL ABOVE THE LINE INDICATED ON THE DUST BAG.
Be sure the disposable paper filter dust bag is installed properly.
4