Desa CRL2718N, CRL3124N, CCL3018NT, CGD3924NT, CGD3018NT, CCL3924N Installing Rear Log

INSTALLATION

Installing Logs (Cont.)

15

INSTALLATION

Continued

Each log is marked with a number. These numbers will help you identify the log when installing. It is very important to install these logs exactly as instructed. Do not modify logs. Only use logs supplied with heater.

1.Place the front log (#1) on the grate fingers. Make sure the front log rests firmly between the grate fingers and the grate base (see Figure 27).

2.Place the base of the middle log (#2) in the U-shaped slots of the grate base. The cutout on the right of the middle log should fit over the burner (see Figure 28). Make sure the front of the middle log is resting on the tabs of the grate base.

3.Locate pins on the bottom of back log (#3). Slide these pins into the holes in the grate base behind the burner (see Figure 29).

4.Locate holes on the bottom of crossover log (#4). Slide front hole onto the left pin (CCL3924NT or CCL3930NTA) or middle pin (CCL3018NT or CCL3018N) on the middle log (#2) and the pin on the back log (#3). See Figure 30 for placement.

5.For CCL3924NT and CCL3930NTA Only: Locate pin and hole on the bottom of crossover log (#5). Slide the pin into the hole located in crossover log (#4). Slide the hole onto the pin on front log (#1). See Figure 31.

For CCL3018NT and CCL3018N Only: Locate holes on the bottom of crossover log (#5). Slide the holes over the left pins on middle log (#2) and front log (#1). See Figure 32.

6.Locate holes on the bottom of crossover log (#6). Slide these holes onto the right pins located in middle log (#2) and front log (#1). See Figure 33.

7.For CCL3930NTA only: Locate holes on the bottom of cross- over log (#7). Slide onto the pins located in crossover log (#6) and middle log (#2). See Figure 34.

8.Add lava rock around base of heater if desired. Do not place any lava rock on logs or burner.

Front Log (#1) Middle Log (#2)

Grate

Fingers

		Burner
Grate Base	Tab	U-Shaped
		Slot
Figure 27 - Installing Front Log	Figure 28 - Installing Middle Log
(#1) (CCL3930NTA Shown)	(#2) (CCL3930NTA Shown)

Pins		Log #4
	Pins
	Log #2	Log #3

Hole in

Grate

Base

Burner
Figure 29 - Installing Rear Log	Figure 30 - Installing Crossover
(#3) (CCL3930NTA Shown)	Log (#4) (CCL3930NTA Shown)
Crossover	Crossover
Log (#4)	Log (#4)

Front Log (#1)	Front
	Log (#1)
Figure 31 - Installing Crossover	Figure 32 - Installing Crossover
Log (#5) (CCL3930NTA Shown) Log (#5) (CCL3018NT and
	CCL3018N Only)
	Holes
		Crossover
Pins	7	Log (#6)
6

Front Log (#1)	Log #2	Pins	Middle
			Log (#2)
Figure 33 - Installing Crossover		Figure 34 - Installing Crossover
Log (#6) (CCL3930NTA Shown)		Log (#7) to Model CCL3930NTA
		Only

For morevisit www..com

107123-01E